Isothermal Crystallization and Melting Behaviors of Nano TiO2‐modified Polypropylene/polyamide 6 Blends

Baoli Ou,Yangjian Ou,Duxin Li,Bo Jing,Yong Gao,Zhihua Zhou,Qingquan Liu
DOI: https://doi.org/10.1002/pc.22205
IF: 5.2
2012-01-01
Polymer Composites
Abstract:Titanium dioxide (TiO2) nanoparticles were functionalized with toluene-2,4-diisocyanate and then polypropylene/polyamide 6/(PP/PA6) blends containing functionalized-TiO2 were prepared using a twin screw extruder. Isothermal crystallization and melting behavior of the as-prepared composites were investigated using differential scanning calorimetry and wide-angle X-ray diffraction. Isothermal crystallization analysis shows that the TiO2 nanoparticles have two effects on PP/PA6 blends, i.e., it can favor the improvement of crystallization ability and decrease the crystallization rate of PP/PA6 blends. The improvement of crystallization ability is superior over decreasement of crystallization rate of PA6 chains caused by TiO2, therefore PA6 in PP/PA6/TiO2 nanocomposites have higher crystallization rate than that of PA6 in pure PP/PA6 blends, which indicated TiO2 nanoparticles favored the crystallization of PA6. The TiO2 nanoparticles show no effects on the equilibrium melting temperature (T?m0) values of PP phase but decreases the T?m0 values of PA6 phase. In addition, the TiO2 nanoparticles did not change the crystalline polymorph of PP/PA6 blends basically; however, favored the formation of beta-PP. POLYM. COMPOS., 2012. (C) 2012 Society of Plastics Engineers
What problem does this paper attempt to address?