Surface modification by air-plasma treatment and its effect on the tribological behavior of hybrid fabric-polyphenylene sulfide composites

Ting Huang,Renguo Lü,Yuning Ma,Pei Liu,Haiming Chen,Zhongyuan Huang,Tongsheng Li

DOI: https://doi.org/10.1080/00222348.2011.625877

2012-01-01

Abstract:Untreated and air-plasma-treated hybrid polytetrafluoroethylene (PTFE)/poly(p-phenylene terephthalamide) (Kevlar) fabrics were used to prepare hybrid fabric-polyphenylene sulfide (PPS) composites by dip-coating in a PPS suspension followed by hot pressing at 295 degrees C for 5 minutes. The tribological properties of the resulting composites were evaluated on a MPX-2000A friction and wear tester with an end-face contact mode. To investigate the surface changes, untreated and treated hybrid fabrics were characterized by using a single fiber tensile test, fabric bonding property test, Fourier transform infrared spectroscopy, scanning electron microscopy, and water contact angle measurements. The results indicated that the air-plasma treatment could significantly improve the tribological behavior of the hybrid fabric-PPS composites. Moreover, the impact of the air-plasma treatment power and time on the tribological properties of the hybrid fabric-PPS composites was systematically studied. An optimum condition of the air-plasma treatment for our equipment was 120 W and 10 minutes. Active carbonyl (C=O) groups were introduced on the surface after the treatment, coupled with an increase in the surface roughness, both of which improved the tribological properties of the hybrid fabric-PPS composites by strengthening the bonding property among the hybrid fabric, PPS, and substrate. On the other hand, excessive air-plasma treatment of the hybrid fabric weakened the tribological properties of the hybrid fabric-PPS composites.