Abstract:The adsorption of Ca on poly(3-hexylthiophene) (P3HT) has been studied by adsorption microcalorimetry, atomic beam/surface scattering, X-ray photoelectron spectroscopy (XPS), low-energy He(+) ion scattering spectroscopy (LEIS), and first-principles calculations. The sticking probability of Ca on P3HT is initially 0.35 and increases to almost unity by 5 ML. A very high initial heat of adsorption in the first 0.02 ML (625-500 kJ/mol) is attributed to the reaction of Ca with defect sites or residual contamination. Between 0.1 and 0.5 ML, there is a high and nearly constant heat of adsorption of 405 kJ/mol, which we ascribe to Ca reacting with subsurface sulfur atoms from the thiophene rings of the polymer. This is supported by the absence of LEIS signal for Ca and the shift of the S 2p XPS binding energy by -2.8 eV for reacted S atoms. The heat of adsorption decreases above 0.6 ML coverage, reaching the sublimation enthalpy of Ca, 178 kJ/mol, by 4 ML. This is attributed to the formation of Ca nanoparticles and eventually a continuous solid Ca film, on top of the polymer. LEIS and XPS measurements, which show only a slow increase of the signals related to solid Ca, support this model. Incoming Ca atoms are subject to a kinetic competition between diffusing into the polymer to react with subsurface thiophene units versus forming or adding to three-dimensional Ca clusters on the surface. At approximately 1.6 ML Ca coverage, Ca atoms have similar probabilities for either process, with the former dominating at lower coverage. Ultimately about 1.6 ML of Ca (1.2 x 10(15) atoms/cm(2)) reacts with S atoms, corresponding to a reacted depth of approximately 3 nm, or nearly five monomer-unit layers. Density-functional theory calculations confirm that the heat of reaction and the shift of the S 2p signal are consistent with Ca abstracting S from the thiophene rings to form small CaS clusters.

Electronic structures and chemical reactions at the interface between Li and regioregular poly (3-hexylthiophene)

Electronic structure and chemical reaction of Ca deposition on regioregular poly(3-hexylthiophene) surfaces

A systematic spectroscopic study of the FePc–Si interfaces

Interface Between Poly (9,9-Dioctylfluorene) and Alkali Metals: Cesium, Potassium, Sodium, and Lithium

Photoelectron Spectroscopic Study of the Interfacial Electronic Structures of Metal‐Ion Containing Polyelectrolytes on ITO Substrates

Study on the Interface of an Organic Semiconductor Grown on Ru(0001) Surface

Interface properties between a low band gap conjugated polymer and a calcium metal electrode

Joint Electrical, Photophysical and Computational Studies on D-Pi-A Dye Sensitized Solar Cells: the Impacts of Dithiophene Rigidification

Formation of the Calcium/Poly(3-Hexylthiophene) Interface: Structure and Energetics

Interface Energy Alignment between Lead Halide Perovskite Single Crystals and TIPS-Pentacene

Interfacial Electronic Structures in an Organic Light-Emitting Diode

At The Polymer Electrolyte Interfaces: The Role Of The Polymer Host In Interphase Layer Formation In Li-Batteries

Long Lived Photoexcitation Dynamics in Π-Conjugated Polymer and Fullerene Blended Films

Electrical, optical and structural characterization of interfaces containing poly(3-alkylthiophenes)(P3ATs) and polydiphenylamine on ITO/TiO2: Interaction between P3ATs polymeric segments and TiO2

Electrochemical intercalation reaction of lithium in the macromolecule with the conjugate double-bond - III. Quantum chemical calculation for intercalation of lithium into the polythiophene

Study of the Interface Interaction Mechanism Between 9,10-Bis(4-(1,2,2-triphenylvinyl) Styryl)anthracene Film and Si Substrate

An in-situ spectroscopy investigation of alkali metal interaction mechanism with the imide functional group

Interfacial electronic structures revealed at the rubrene/CH3NH3PbI3 interface

Characterization of Li+ Transport through the Organic-Inorganic Interface by Using Electrochemical Impedance Spectroscopy

Alkali metal storage mechanism in organic semiconductor of perylene-3,4,9,10-tetracarboxylicdianhydride

Gently does it!: in situ preparation of alkali metal-solid electrolyte interfaces for photoelectron spectroscopy