Abstract:It has recently been shown that solid-state nanometer-scale pores ('nanopores') can be used as highly sensitive single-molecule sensors. For example, electrophoretic translocation of DNA, RNA and proteins through such nanopores has enabled both detection and structural analysis of these complex biomolecules. Control over the nanopore size is critical as the pore must be comparable in size to the analyte molecule in question. The most widely used fabrication methods are based on focused electron or ion beams and thus require (scanning) transmission electron microscopy and focused ion beam (FIB) instrumentation. Even though very small pores have been made using these approaches, several issues remain. These include the requirement of being restricted to rather thin, mechanically less stable membranes, particularly for pore diameters in the single-digit nanometer range, lack of control of the surface properties at and inside the nanopore, and finally, the fabrication cost. In the proof-of-concept study, we report on a novel and simple route for fabricating metal nanopores with apparent diameters below 20 nm using electrodeposition and real-time ionic current feedback in solution. This fabrication approach inserts considerable flexibility into the kinds of platforms that can be used and the nanopore membrane material. Starting from much larger pores, which are straightforward to make using FIB or other semiconductor fabrication methods, we electrodeposit Pt at the nanopore interface while monitoring its ionic conductance at the same time in a bi-potentiostatic setup. Due to the deposition of Pt, the nanopore decreases in size, resulting in a decrease of the pore conductance. Once a desired pore conductance has been reached, the electrodeposition process is stopped by switching the potential of the membrane electrode and the fabrication process is complete. Furthermore, we demonstrate that these pores can be used for single-biomolecule analysis, such as that of λ-DNA, which we use in a proof-of-concept study. Importantly, our approach is applicable to single nanopores as well as nanopore arrays, and can easily be extended to deposits of metal other than Pt.

Fast and controllable fabrication of suspended graphene nanopore devices.

Fabrication of Sub-Nanometer Pores on Graphene Membrane for Ion Selective Transport

EFFICIENT CONTROL OF DNA TRANSPORT IN NANOPORE-BASED NANOFLUIDIC TRANSISTORS

Controllable Fabrication of Sub-10 nm Graphene Nanopores via Helium Ion Microscopy and DNA Detection

Atomically thin molybdenum disulfide nanopores with high sensitivity for DNA translocation.

A simple method for fabricating free-standing large area fluorinated single-layer graphene with size-tunable nanopores

Facile and Ultraclean Graphene-on-Glass Nanopores by Controlled Electrochemical Etching

Nanomanufacturing of Graphene Nanosheets Through Nano-Hole Opening and Closing

Dry transfer method for suspended graphene on lift-off-resist: simple ballistic devices with Fabry-Pérot interference

Fabrication of Nanopore in Graphene by Electron and Ion Beam Irradiation: Influence of Graphene Thickness and Substrate

Nanopore-based DNA Analysis Via Graphene Electrodes

Rapid fabrication of solid-state nanopores with high reproducibility over a large area using a helium ion microscope.

Fast detection of water nanopockets underneath wet-transferred graphene

Precise electrochemical fabrication of sub-20 nm solid-state nanopores for single-molecule biosensing

Fabrication and practical applications of molybdenum disulfide nanopores

Fabrication of solid-state nanopores

Selective Capture and Manipulation of DNA through Double Charged Nanopores

Large-Area Nanogap-Controlled 3D Nanoarchitectures Fabricated via Layer-by-Layer Nanoimprint

Fabricatable Nanopore Sensors with an Atomic Thickness

Low-cost and Convenient Fabrication of Polymer Micro/Nanopores with the Needle Punching Process and Their Applications in Nanofluidic Sensing

Fabrication of Nanopores in a Graphene Sheet with Heavy Ions: A Molecular Dynamics Study