Abstract:Magnetic fractions (MFs) in fly ashes from eight coal-burning power plants were extracted by magnetic separation procedure. Their mineralogy and potential leachability of heavy metals were analyzed using rock magnetism, X-ray diffraction (XRD), scanning electron microscopy equipped with energy-dispersive X-ray spectroscopy (SEM/EDX) and leaching procedures (toxicity characteristics leaching procedure by the United States Environmental Protection Agency, TCLP, and gastric juice simulation test, GJST). Results show that the MFs in the fly ashes range between 2.2 and 16.3wt%, and are generally composed of magnetite, hematite, quartz and mullite. Thermomagnetic analysis and SEM/EDX indicate that the main magnetic carrier magnetite is substituted with small amounts of impure ions, and its structures are featured by rough, dendritic and granular iron spherules. The MFs are found to be rich in Fe, Mn, Cr, Cu, Cd and Pb. Compared with the non-magnetic fractions (NMFs), the MFs have about 5 times higher iron, and 1.6 times higher Mn, Cr, Cu and Cd concentrations. The TCLP test shows that the TCLP-extractable Cr, Cu, and Pb concentrations in the MFs are higher than those in the NMFs, while the TCLP-extractable Cd concentration in the MFs and NMFs is below the detection limit (<0.1mg/L). The GJST-extractable Cd, Cr, Cu, and Pb concentrations in the MFs are higher those in the NMFs. No significant difference in the leachability ratio of Cr, Cu and Pb with TCLP and GJST is found in the MFs and NMFs. However, the GJST test showed that Pb has higher leachability in MFs than that in NMFs. The leachability ratio of heavy metals has an order of Cu>Cr>Pb>Cd. The heavy metals of fly ashes have a great potential to be released into the environment under acid environment.

Heavy metal characterization of circulating fluidized bed derived biomass ash.

Content, Mobility and Transfer Behavior of Heavy Metals in Mswi Bottom Ash in Zhejiang Province, China

Analysis of Formation and Growth Process of Ash Deposition on the Convective Heating Surface of a 400t/d MSW Incinerator Based on Different Operating Days

Stabilization of Heavy Metals in Municipal Solid Waste Circulating Fluidized Bed Incineration Fly Ash by Fusion–hydrothermal Method

Characterization of Dioxins and Heavy Metals in Chelated Fly Ash

Leaching of Heavy Metals from MSWI Fly Ash: Experiments Vs. Simulation

Investigation of Ash Deposition Dynamic Process in an Industrial Biomass CFB Boiler Burning High-Alkali and Low-Chlorine Fuel

Experimental study on ash deposition and corrosion in a CFB boiler co-firing biomass with coal

Enrichment of Heavy Metals and Organic Pollutants in Fly Ash Emitted from CFB During the Combustion of Coal Blended with Petroleum Coke

Heavy metals behavior of co-combustion ash from sewage sludge and coal slime: Temperature and mixing ratio dependence, interactions and speciation

Microwave-Assisted Hydrothermal Treatment with Soluble Phosphate Added for Heavy Metals Solidification in MSWI Fly Ash

Study on heavy metals leaching toxicity of fly ash and bottom slag from oil shale CFB

HEAVY METALS EMISSION FROM A FLUIDIZED-BED MSW INCINERATOR

Characterising boiler ash from a circulating fluidised bed municipal solid waste incinerator and distribution of PCDD/F and PCB

Effects of Hydrothermal Treatment on the Major Heavy Metals in Fly Ash from Municipal Solid Waste Incineration

Experimental research on heavy metals emission from fluidized bed with stone coal fired

Sequential leaching of heavy metals and sulfur in bottom ash and fly ash from the co-combustion of wood and peat at a municipal district heating plant

LEACHING BEHAVIOR OF HEAVY METALS FROM MSWI FLY ASH

Mineralogy and heavy metal leachability of magnetic fractions separated from some Chinese coal fly ashes

Morphochemical investigation on the enrichment and transformation of hazardous elements in ash from waste incineration plants

Study on the Deposits Derived from a Biomass Circulating Fluidized-Bed Boiler