Abstract:A method based on a dual-channel gas chromatograph equipped with three columns and three detectors was established for the determination of individual components in finished motor gasoline. The gasoline samples were separately introduced into the two injection ports of the chromatograph using two autosamplers. The components of the sample introduced into the first injection port (channel 1) were separated on a nonpolar PONA column (50 m×0.20 mm×0.5 μm) for gasoline analysis and detected by an flame ionization detector (FID). The components of the sample introduced into the second injection port (channel 2) were separated on another PONA column. Oxygenates (e.g., ethers and alcohols), other unconventional and prohibited additives that would co-elute with the hydrocarbons (e.g., methylal, dimethyl carbonate, sec-butyl acetate, and anilines), and some difficult-to-separate hydrocarbon pairs (e.g., 2,3,3-trimethylpentane and toluene) eluted from the PONA column and entered a DM-624 column (30 m×0.25 mm×1.4 μm) to achieve further separation according to the switch timetable using the Deans switch procedure and detected by an FID. The peak of 3-methylpentane, a common component in gasoline samples, also entered the DM-624 column by the Deans switch procedure for calculation purposes. The peak areas of target components on the PONA column in channel 1 were calculated using the peak areas on the DM-624 column as well as those of 3-methylpentane on both the DM-624 and PONA columns in channel 1 with a calibration factor between the two channels. The peak areas of co-eluted components were obtained by subtracting the calculated peak areas of the target components from those of the co-eluted peaks. The mass percentages of the individual components were calculated according to the normalization method using all peak areas on the PONA column in channel 1 with relative response factors. The mass percentages of the oxygenates, anilines, and individual hydrocarbons were determined, and the group-type distribution was calculated according to the carbon number. Separation and quantitation interferences between the additives and hydrocarbons were eliminated using this procedure. Twenty oxygenates and unconventional additives, each with a mass percentage of approximately 3%, were added to a real motor gasoline-92 sample and analyzed using the proposed method. The recoveries of the target components were between 90.1% and 118.2% with relative standard deviations (RSDs) between 0.2% and 5.1% (n=6). The analysis of a real ethanol-gasoline sample showed that the RSDs of contents of most components was less than 3% (n=6). Because the heart-cut of peaks using Deans switch technique requires the precise repeatability of retention times, the retention-time repeatability of components on the PONA column in channel 2 was investigated over an extended period of time after thousands of runs of real-sample analysis. The retention times of the same component in several randomly selected motor gasoline-92 samples varied from 0.01 to 0.03 min, indicating that the proper timetable for the Deans switch remained stable for two years. The precise repeatability of retention times was achieved owing to the high precision of the electric pneumatic control of the chromatograph and the stability of the column used. Real finished motor gasoline samples with different octane numbers (gasoline-92, gasoline-95, and ethanol gasoline-95) were analyzed using the developed method, and the results acquired were consistent with those of standard methods (GB/T 30519-2016, NB/SH/T 0663-2014, and SH/T 0693-2000). If some unconventional additives (such as methylal) were added to gasoline samples, the contents of these unconventional additives could also be detected, which means one run of the proposed method could provide results corresponding to three or four runs of different standard methods. The acquisition of information on the individual components of finished motor gasoline will assist in research on precise gasoline blending.

Gas Dispersion Concentration of Trace Inorganic Contaminants from Fuel Gas and Analysis Using Head-Column Field-Amplified Sample Stacking Capillary Electrophoresis.

Determination of trace anions in liquefied petroleum gas using liquid absorption and electrokinetic migration for enrichment followed by ion chromatography.

Investigation of Aromatic Impurities in Liquefied Petroleum Gas by Solid-Phase Extraction Sampling Coupled with Gas Chromatography-Mass Spectrometry

Non-target Screening of Organic Pollutants in Sediments and Sludges Using Gas Chromatography-Mass Spectrometry and Automated Mass Spectral Deconvolution

Application of Extraction Induced by Emulsion Breaking for Trace Multi-Element Determination in Jet Fuel by Inductively Coupled Plasma-Mass Spectrometry

Coupling nanoliter high-performance liquid chromatography to inductively coupled plasma mass spectrometry for arsenic speciation.

Development of New Method of Δ13c Measurement for Trace Hydrocarbons in Natural Gas Using Solid Phase Micro-Extraction Coupled to Gas Chromatography Isotope Ratio Mass Spectrometry.

Applications of GFC-IFC in Trace Multi-Component Gas Analysis

Analysis of sulfur-containing odorous gas mixture by capillary gas chromatography

On-line nonmetal detection for argon supercritical fluid extraction using inductively coupled plasma optical emission spectroscopy

Fluorescence Noise Eliminating Fiber-Enhanced Raman Spectroscopy for Simultaneous and Multiprocess Analysis of Intermediate Compositions for C2H2 and H2 Production

On-site sampling of inorganic contamination on the metal surface and analysis with capillary electrophoresis.

[Determination of individual components in finished motor gasoline by dual-channel three-column gas chromatography]

Concentrically Packed High Flow Air Sampler for Parts-Per-trillion Volatile and Semi-Volatile Organica Compounds

Development of Gas Chromatography-Flame Ionization Detection System with A Single Column and Liquid Nitrogen-Free for Measuring Atmospheric C2-C12 Hydrocarbons

A novel gas liquid separator for direct sampling analysis of ultratrace arsenic in blood sample by hydride generation in-situ dielectric barrier discharge atomic fluorescence spectrometry

Development of a new method for hydrogen isotope analysis of trace hydrocarbons in natural gas samples

Ag/ZnO Nanocomposite-Decorated Capillary for Rapid Trace Gas Identification Based on Surface-Enhanced Raman Scattering under Ambient Conditions

On-line scavenging of trace analytes in complex matrices for fast analysis by carbon dioxide bubbling extraction coupled with gas chromatography-mass spectrometry.

Contribution of System Components to Dispersion in the Analysis of Microvolume Samples by Flow-Injection Flame Atomic-Absorption Spectrometry

Simple field-based automated dispersive liquid-liquid microextraction of trace level phthalate esters in natural waters with gas chromatography and mass spectrometric analysis.