Nitrate removal from drinking water by a three-dimensional biofilm-electrode reactor

姚静华,赵国智,田光明,张建华,徐文江
DOI: https://doi.org/10.13671/j.hjkxxb.2012.06.011
2012-01-01
Abstract:The performance of a three-dimensional biofilm-electrode reactor (3D-BER) was tested under different conditions. Results showed that nitrate removal efficiency increased when the current intensity increased from 0 mA to 100 mA. The highest nitrate removal efficiency of 73.8% was achieved at the current of 100 mA, and the nitrate concentration in the effluent was 8.27 mg· L^-1. However, with a further increase of the current intensity from 100 mA to 150 mA, the nitrate removal efficiency decreased slightly. With the current intensity increased from 0 mA to 150 mA, the nitrite generation increased in the beginning then decreased. The accumulation of nitrite was the most serious when the current was 60 mA. It was founded that the otimum temperature for denitrification was from 31 ℃ to 35 ℃ , with nitrate concentrations in effluent less than 10 mg· L^-1. A nitrate removal efficiency up to 85.5% was achieved at 35 ℃. Results showed that appropriate pH for denitrification was between 7.2 and 8.2, with nitrite concentrations in effluent lower than 1 mg· L^-1. The 3D-BER had a good pH buffer capacity. When the pH of the influent increased from 5.5 to 9.0, pH of the effluent ranged between 7.6 and 8.2, with the nitrate removal efficiency between 59.6% and 80.2%. In addition, the current intensity, temperature and pH also influenced the concentrations of ammonia nitrogen in the effluent and the removal efficiency of the total phosphorus ( TP). Probable causes of TP removal and ammonia nitrogen generation were also discussed by comparing the performance of the 3D-BER with an electrochemical reactor.
What problem does this paper attempt to address?