Abstract:A single stage cryogenic liquid turbine is developed for replacing the Joule-Thompson valve and recovering energy from the liquefied air during throttling process in the large-scale internal compression air-separation unit, and evaluation of the impeller axial thrust at different conditions is essential for a reliable bearing design and stable operation. To predict the axial thrust load, a numerical model is established to simulate the turbine flow in a turbine stage environment, which includes the main flow domain (an asymmetrical volute, variable geometry nozzle, impeller, and diffuser), impeller front and back side gaps, and shaft seal leakage. Numerical simulation of flow is conducted by using the ANSYS-CFX. Flow characteristics in both main flow domain and impeller side gaps of the turbine stage are captured and analyzed. The axial thrust is then calculated based on the obtained pressure data in the impeller and its front and side gaps by using a direct integration approach.Flow behaviour in both main flow domain and impeller side gaps has been well exhibited by the numerical results. At the impeller back side gap inlet, the back flow is encountered even for design condition and it returns the impeller main flow stream; the impeller side gap flow has much influence on the axial thrust. To investigate influence of turbine operation condition on axial thrust, flow simulation is conducted at different mass flow rates and inlet pressure for the turbine stage, based on which the axial thrust is calculated. It is demonstrated from the obtained numerical results that the axial thrust increases as the inlet pressure increases and decreases as turbine flow rate increases. Geometry parametric study is conducted for the shaft seal clearances, which has demonstrated that the axial thrust is influenced largely by the clearance size and it decreases as the clearance grows.For the purpose of comparison, the empirical method is also used to predict the axial thrust load. The obtained results are compared to the numerical ones and evident deviation of the empirical from the numerical exists and the reason is that axial force components caused by the impeller main flow stream and its side gap flow are approximated very roughly in the empirical method.

Numerical Study of Cavitating Behavior in A Cryogenic Liquid Turbine

Numerical Investigation Of A Cryogenic Liquid Turbine Performance And Flow Behavior

Cavitation Suppression and Design Optimization in a Cryogenic Liquid Turbine Expander Based on Thermodynamic Cavitation and Entropy Production Analysis

Influence of Impeller Fairing Cone Geometry on Cavitating Flow Behavior in A Cryogenic Liquid Turbine Expander

Cryogenic Cavitation Mitigation in a Liquid Turbine Expander of an Air-Separation Unit through Collaborative Fine-Tuned Optimization of Impeller and Fairing Cone Geometries

Three-dimensional Numerical Simulation of Cryogenic Cavitating Flows of Liquid Nitrogen Around Hydrofoil

Numerical Simulation of Liquid Nitrogen Around Hydrofoil Cryogenic Cavitation

Validation of Full Cavitation Model in Cryogenic Fluids

Swirling and cavitating flow suppression in a cryogenic liquid turbine expander through geometric optimization

Investigation Of Impeller Strength For A Cryogenic Liquid Turbiine

Prediction of Axial Thrust Load Acting on a Cryogenic Liquid Turbine Impeller

Numerical Studies on Two-Phase Flow in Cryogenic Radial-Inflow Turbo-Expander Using Varying Condensation Models

Investigation of the cavitation model in an inducer for water and liquid nitrogen

Computational Modeling of Cavitating Flows in Liquid Nitrogen by an Extended Transport-Based Cavitation Model

Cavitation in Cryogenic Fluids: A Critical Research Review

Numerical simulation of cavitating flow of cryogenic liquids through a Venturi tube.

Numerical Simulation of Cavitation Flow under High Pressure and Temperature

Study of the Flow in a Cryogenic Pump under Different Cavitation Inducements by Considering the Thermodynamic Effect

Computational fluid dynamic study on cavitation in liquid nitrogen

Modeling Cavitation Flow of Cryogenic Fluids with Thermodynamic Phase-Change Theory

Modeling of Turbulent,isothermal and Cryogenic Cavitation under Attached Conditions