Abstract:This study presents a multi-round shape optimization method based on the aerodynamic reduced order model. In this method, each optimization round employs the first-order Taylor reduced order model to provide aerodynamic characteristics in the local design space around the baseline point. At the end of each optimization round, the baseline point moves toward the optima and a new reduced order model is built at the new baseline point for the next optimization round. In this way, the provided method explores the whole design space. The NACA0012 airfoils in subsonic and transonic flows are used to verify the method with the lift-drag ratio as optimization objective. The design parameters are the shape control parameters of the airfoil. The optimization algorithm is a genetic algorithm. After a total of 20 simulations by two rounds of optimizations, the lift-drag ratios increase from 0 to 25 and from 0 to 8 in the subsonic case and transonic case, respectively. An additional trick was suggested for addressing shockwave effect in the transonic case, in which the influence of the airfoil shape on the aerodynamic forces is divided into the following two parts: the smoothed part to address the influence of the shape on the smooth aerodynamic distribution, and the shockwave part to address the influence of the shape on shockwave strength, shockwave position, and their effect on the aerodynamic distribution. The optimizations of the airfoils in subsonic and transonic flows yield different trends. The results of the subsonic case tend to increase the airfoil curvature to increase the lift-drag ratio. The results of the transonic case tend to move the upper surface shockwave to the trailing edge, while moving the lower surface shockwave to the leading edge. Independent of the case, the provided optimization method can properly address the resulting trends and increase the efficiency of the optimization.

Design of laminar supercritical airfoils based on navier-stokes equations

Aerodynamic Design of Transonic Natural-Laminar-Flow (NLF) Wing Via Surrogate-basedGlobal Optimization

Robust Design of Natural Laminar Flow Supercritical Airfoil by Multi-Objective Evolution Method

Multi-objective Inverse Design of Natural Laminar Flow Airfoils

Supercritical Wing Design and Optimization for Transonic Civil Airplane

Supercritical natural laminar flow airfoil optimization for regional aircraft wing design

Laminar flow wing ’ s optimization design by rans solver with automatic transition prediction

Multi-point/objective Optimization Design of High Lift-to-drag Ratio for NLF Airfoils

Multi-objective Optimization Design for Airfoils with High Lift-to-drag Ratio Based on Geometric Feature Control

Optimum Aerodynamic Design of Transonic Wing Based on Viscous Adjoint Method

Aerodynamic shape optimization by continually moving ROM

Aerodynamic Design Method Based on Control Theory and Navier-Stokes Equations

Design Methodology Using Characteristic Parameters Control for Low Reynolds Number Airfoils

Aerodynamic Optimization Design of Low-Speed Airfoil Based on Response Surface Methodology

Aerodynamic Shape Optimization of Natural-Laminar-Flow Wing Using Surrogate-Based Approach

Study of Boundary Layer Transition on Supercritical Natural Laminar Flow Wing at High Reynolds Number Through Wind Tunnel Experiment

High Subsonic NLF Airfoil Design at Low Reynolds Number

Problems in optimization design of HLFC sweep wing

Supercritical wing design based on airfoil optimization and 2.75D transformation

Design of airfoil with high ratio of lift over drag

Robust Design of NLF Airfoils