Abstract:In this paper, a calibration method applied to Successive Approximation Register (SAR) Analog-to-Digital Converter (ADC) is designed, especially applied to the capacitive array in resistive–capacitive combined SAR ADC. Conventionally, auxiliary Digital-to-Analog Converter (DAC) foreground calibration, dynamic element matching (DEM) or digital background calibration are widely used to enhance linearity of data converters. This paper proposes an off-line capacitor selection calibration method that uses an optimal sequence of unity elements for an overall improvement of Signal to Noise and Distortion Ratio (SNDR), Spurious-Free Dynamic Range (SFDR), differential nonlinearity (DNL) and integral nonlinearity (INL). It is worth mentioning that the capacitor mismatch only needs to be calibrated after power on, this kind of foreground calibration will not increase the power consumption of ADC during the normal operation, while the background calibration will consume power consumption all the time. It is important that the calibration proposed is highly relied on a high resolution comparator. This paper provides a high resolution comparator design, the resolution of the comparator reaches 8.35 μV, which already satisfies the demand of a 18-bit differential SAR ADC. During the process of calibration, all capacitors are divided into unit capacitors, and then the capacitors are sorted, reorganized to form each bit. The calibration method is verified by simulating a 18-bit SAR ADC with 500 Monte-Carlo runs, the simulation results show that the average value of SFDR is enhanced by about 36 dB and the average value of SNDR is enhanced by about 27 dB. Therefore, the proposed method is simple and significantly improves the static and dynamic performance of the ADC without obvious additional hardware, and greatly saves area and power consumption. Finally, it is worth mentioning that in high-precision SAR ADCs design, especially above 16 bits, comparator noise and the voltage coefficient of capacitors are the main factors limiting ADC performance, which are not considered in this work.

A Wide-Range and High-Precision Real-Time Calibration for Dynamic Comparator

A 15-Bit, 5 MSPS SAR ADC with On-Chip Digital Calibration

A 16-Bit 2.5-Ms/s SAR ADC with On-Chip Foreground Calibration

Modeling of a 14-bit, 100-MS/s pipelined ADC with digital nonlinearity calibration

A Low-Power Area-Efficient Wide-Range Offset Calibration Technique for High-Speed High-Resolution Comparator

A Calibration Scheme for a 800-Ms/s 14 Bit Pipelined ADC in 28-Nm CMOS

An Effective DC Offset Calibration Method Combined with Analog and Digital Circuits for Direct Conversion Receivers

A Low-Offset Calibration-Free Comparator with a Mismatch-Suppressed Dynamic Preamplifier

A Low Kickback Noise and Offset Calibrated Dynamic Comparator for 2b/c Sar Adc

A novel capacitor recombination calibration method applied to 18-bit SAR ADC

Capacitor mismatch calibration for SAR ADCs based on comparator metastability detection

A Low-Offset Dynamic Comparator with Input Offset-Cancellation

A 16-Bit 300-Ks/s Foreground Calibration SAR ADC with Single-Ended/differential Configurable Input Modes

A Digital Background Calibration Circuit for Coarse-Fine Timing Mismatch in VCO-Based ADCs

A Digital Calibration Technique for an Ultra High-Speed Wide-Bandwidth Folding and Interpolating Analog-to-digital Converter in 0.18μm CMOS Technology

Non-binary Digital Calibration for Split-Capacitor DAC in SAR ADC

A 1 . 4 Mw 8 B 350 MS / S Loop-Unrolled SAR ADC with Background Offset Calibration in 40 Nm CMOS

A Wideband Timing Mismatch Calibration Design for Time-Interleaved Analog-to-Digital Converters with Fast Convergence

The Effects of Comparator Dynamic Capacitor Mismatch in SAR ADC and Correction

A Digital Calibration Technique with High Speed and Low Complexity

A 0.2-Mv 20-Mhz 600-Μw Comparator