Abstract:The smooth joint contact model has been used extensively to simulate the shear behaviour of joints in the numerical simulations with particle flow code. Results from existing studies have revealed that this model suffers from the particle interlocking problem taking place at the shear displacement greater than the minimum particle diameter. To solve this problem, the shear box genesis approach was proposed, by which particles in the upper and lower halves of a joint are generated separately, and the intended joint plane will be added as a common boundary. However, the shear box genesis approach is not a satisfactory solution to the interlocking problem yet. Three problems are usually encountered in practice: first, particles are still likely to move across the intended joint plane and cause the interlocking; second, the shear box genesis approach inevitably causes the periodic change in the contact number along the intended joint plane; third, it is difficult to incorporate the nonlinear closure behaviour of joints. Therefore, this paper aims to solve the shortcomings, and to apply the improvements to the simulation of joint shear behaviour. The interlocking problem was successfully solved by introducing the joint side checking method, and specifying the value of maximum allowed closure. The periodic stress fluctuation during shearing was eliminated by the non-unified ball generation method. The nonlinear closure behaviour of joints was captured by embedding the Barton–Bandis model. To verify the applicability of the improvements to rough joints, a series of numerical and experimental direct shear tests of rough joints were conducted. In general, good agreements were achieved between the numerical modelling results and laboratory measurements. This improved shear box genesis approach enhances the ability of the smooth joint contact model to simulate the shear behaviour of joints, and also has the ability to track the damage evolution during the joint shearing process.

Numerical simulation of non-linear joint using displacement discontinuity method

Propagation Simulation and Dilatancy Analysis of Rock Joint Using Displacement Discontinuity Method

Dynamics Numerical Analysis of Space Deployable Mechanism with Three-Dimensional Clearance Revolute Joint

Experimental and Numerical Investigation on Shear Failure Behavior of Rock-like Samples Containing Multiple Non-Persistent Joints

Simulation of the Nonlinear Mechanical Behaviors of Jointed Rock Masses Based on the Improved Discontinuous Deformation and Displacement Method

Development of Discontinuous Deformation Analysis with Displacement-Dependent Interface Shear Strength

Numerical Analysis on Crack Propagation under Compressing Load by Displacement Discontinuity Method

An Integrated Joint Dynamics System for Elastically Jointed Structures

Numerical Simulation of Cohesive Discontinuities in Jointed Rockmass Based on Element Partition Method

Modelling the shearing behaviour of joints using an improved shear box genesis approach in particle flow code (2D) and its validation

Simulation of Deformation Process Failure of Jointed Rock Masses Based on the Numerical Manifold Method

Prediction of Wave Attenuation Across Multiple Joints with an Improved Elastic Nonlinear Model

A hybridized DDA-DDM for modeling jointed rock masses

High-efficiency Nonlinear Dynamic Analysis for Joint Interfaces with Newton–Raphson Iteration Process

Three-dimensional numerical simulation of dynamic strength and failure mode of a rock mass with cross joints

Numerical Analysis of Crack under Compression by 3D Displacement Discontinuity Method

DDM Regression Analysis of the In-Situ Stress Field in a Non-Linear Fault Zone

Numerical Investigations of the Dynamic Shear Behavior of Rough Rock Joints

Modeling and 2-D discrete simulation of dislocation dynamics for plastic deformation of metal

DDM Analysis of the Effect of Non-Linear Structural Plane on In Situ Stress Field

An improved nonlinear dynamic reduction method for complex jointed structures with local hysteresis model