Abstract:The evolution of the local stress field of faults under tectonic stresses is crucial to predict earthquakes. In this study, we investigated the stress sensitivity of an analogue fault model with dimensions of 2 m × 1 m × 1 m, prepared from cement, gypsum, river sand, putty powder, and borax mixture. The angle between the fault strike and the maximum stress direction was varied, and the variation in the stress near the analogue fault (area 1200 × 400 mm; width 5 mm) was determined. The crack growth law of the analogue fault was found to be consistent with a simple Riedel shear model. A main strike-displacement zone was formed, and its direction was parallel to that of the analogue fault. Fault development was described by three stages based on stress–strain relationships: a nucleus stage, a stable growth, and an unstable growth stage. The deflection angle (the deflection angle of the local principal stresses) range of the local stress field was (− 45°, 45°), and it varied most significantly in the nucleus stage. The closer to the fault, the greater the variation range in the deflection angle. The variation range was greater in the fault compression quadrants than in the dilatation quadrants. The correlation between the deflection angle and the relative deformation velocity of the fault was stronger in the stable growth stage than in the other stages. In this stage, the angle–deformation–velocity correlation could be well fitted using a logistic trend model. These findings can be of importance to better understand the nucleation and mechanisms of fault slip-induced earthquakes under varying fault-strike-stress conditions.

DDM Regression Analysis of the In-Situ Stress Field in a Non-Linear Fault Zone

Regression Analysis of Initial Stress Field Around Faults Based on Fault Throw by Displacement Discontinuity Method

Modeling Rock Failure Using the Numerical Manifold Method Followed by the Discontinuous Deformation Analysis

A Cohesive Model-Based Nonlinear Discontinuous Deformation Analysis for Tensile Fracture in Geotechnical Materials

Development of Discontinuous Deformation Analysis with Displacement-Dependent Interface Shear Strength

Improved Discontinuous Deformation Analysis Method for Modeling Tensile Cracking in Quasi-Brittle Materials

DDM Analysis of the Effect of Non-Linear Structural Plane on In Situ Stress Field

Three Dimensional FE Regression Analysis of Multivariate Geo-stress Field of Muzhailing Tunnel

Analysis of Near-Field Stresses in an Analogue Strike-Slip Fault Model

Extended DDA with Rotation Remedies and Cohesive Crack Model for Simulation of the Dynamic Seismic Landslide

Simulation of the Nonlinear Mechanical Behaviors of Jointed Rock Masses Based on the Improved Discontinuous Deformation and Displacement Method

Stress Distribution in Direct Shear Loading and its Implication for Engineering Failure Analysis

Study on Fitting Analysis of Initial Stress Field in Rock Masses

Initial ground stress field regression analysis and application in an extra-long tunnel in the western mountainous area of China

A novel anisotropic deterioration mechanical model for rock ductile–brittle failure under 3D high-stress and its application

Modified discontinuous deformation analysis with mixed bilinear failure model for investigating quasi-brittle failure in geo-materials

Multi-scale elasto-plastic calibration of the regression analysis of 3D initial crustal stress field

Propagation Simulation and Dilatancy Analysis of Rock Joint Using Displacement Discontinuity Method

Equivalent discontinuum analysis of stress and displacement in underground rock masses

Finite Element Method Regression Back Analysis of Initial Stress Field in a Large Underground Chamber Area

Method to quantify the dynamic near-fault full-field stress evolution associated with rough fault shear deformation based on 3D printed models and photoelastic measurements