Abstract:As aircraft altitude increases, the effects of air rarefaction become significant. Inside the engine, heat transfer at the turbine blade wall shows a unique pattern under low Reynolds number conditions. In this paper, the influence of low Reynolds number flow transition on heat transfer is investigated using experimental and numerical simulation methods. Three blades without film holes are installed in the wind tunnel. Heat transfer at the middle vane wall is measured by transient liquid crystal technology. Two turbulence models, including the SST and SST-γ-Reθ transition, were used to simulate both fully turbulent heat transfer processes and heat transfer processes taking the transition into account. Three parameters discussed include Reynolds number (Re), turbulence intensity (Tu) and wall roughness (Rk). Five Re numbers covering a wide range from 0.3 × 105 to 2.6 × 105, are selected to study the heat transfer of low Re. In this part, Tu is 16.9 %. Two Tu values (2.3 % and 15.7 %) and three Rk values (5um, 10um and 15um) are then specified in the simulation boundary conditions. In comparison, their effects were examined. The results indicate that the mainstream is laminar for case of Re = 0.3 × 105. As Re increases, transition and following turbulence appears and develops at downstream of both sides. However, the normalized heat transfer Nu increases at different rate. At high Re, the transition limits further increase in Nu. Tu effects strongly change the flow state. For results of Re = 1.5 × 105 and 3.0 × 105, high Tu increases Nu by 2/3 in the laminar region while maintaining the same magnitude of Nu in the turbulent region. Rk can change the pressure distribution on the wall, increasing the pressure gradient and thus delaying the occurrence of the transition. The distribution of Nu shows that Nu increases with increasing Rk in the turbulent region, while the opposite is true in the laminar zone.

Measurement of the Transition and Separation for Turbine Blade Boundary Layer with Low-Reynolds Number

Les and Cdns Investigation of T106c Low Pressure Turbine

Large Eddy Simulation and CDNS Investigation of T106C Low-Pressure Turbine

Roughness Effects on Flow Losses of a High-Lift Low-Pressure Turbine Cascade

Statistical Investigations of Profile Error Impact on Flow and Performance of a Low-Pressure Turbine Cascade

Numerical Study of the Boundary Layer Separation of a Low‐Pressure Turbine Cascade at Different Incidence Angles

A numerical study on vane heat transfer characteristic at low Reynolds number conditions

Study On Flow Separation And Transition Of The Airfoil In Low Reynolds Number

Numerical Investigation of Boundary Layer Separation Control on the Low-Pressure Turbine Blade by Oscillatory Blowing

Numerical and Experimental Studies on Separated Boundary Layers over Ultra-High Lift Low-Pressure Turbine Cascade Airfoils with Variable Solidity: Effects of Free-stream Turbulence

Study on the transition mechanism of vibrating low-pressure turbine blades based on large Eddy simulation

Measurements of Heat Transfer and Pressure in a Trailing Edge Cavity of a Turbine Blade

Numerical study of flow in low-pressure turbines with undulated suction surface

The Effect of Fsti to the Combined Separation Control Strategy of Surface Roughness with Upstream Wakes

Separation-induced transition on a T106A blade under low and elevated free stream turbulence

Numerical Investigation of Separation-Induced Transition in a Low-Pressure Turbine Cascade in a Low-Disturbance Environment

A numerical investigation of application of bowed blade to control flow separation on highly loaded turbine

Numerical investigation of distributed roughness effects on separated flow transition over a highly loaded compressor blade

Numerical Investigation on Ultra-High-lift Low-Pressure Turbine Cascade Aerodynamics at Low Reynolds Numbers Using Transition-Based Turbulence Models

Large-Eddy Simulation of the Boundary Layer Development in a Low-Pressure Turbine Cascade With Passive Flow Control

Investigation of the Discharge Coefficient for Laidback Fan-Shaped Holes on Turbine Blades Under Internal Crossflow Condition