Abstract:This paper proposes a new configuration of the dual-channel inlet with an isometric isolation section and uses numerical simulation to investigate its performance concerning off-design conditions. The starting performances of the dual-channel inlet are compared with a single-channel one under variable Mach numbers. The RANS method with a new non-linear turbulence model, the Quadratic Constitutive Relation (QCR) model, is utilized to calculate the inlet's flow field and performance. Numerical results show that the designed single- and dual-channel inlets significantly broaden the starting range, allowing for starting at incoming flow speed below M = 4. The dual-channel inlet achieves start at the angle of attack (AOA) of − 8°, 0°, and 8°, and the angle of sideslip (AOS) of 0°, 4°, and 8°. However, the blunt head between the dual-channel inlet induces detached shock waves, which coupled with the leading edge shock waves, can alter the incoming flow conditions in the inner runner. The single-channel inlet outperforms the dual-channel inlet, as the latter's S-transition section has a significant impact on its performance. This section exhibits complicated flow phenomena with secondary flows, vortex, and shock wave/boundary layer interactions (SBLI), leading to a lower total pressure recovery coefficient (TPR). Moreover, blunt heads and S-transition sections are the predominant factors contributing to considerable total pressure losses, consequently leading to a general decrease in the inlet system performance. It is therefore imperative to meticulously design and optimize the guide mechanism at the entrance and S-transition sections to take full advantage of the outstanding performance of the dual-channel inlet.

Finite Element Analysis and Optimization of the Inlet Test Installation for Aircraft with High AOA Maneuver

Optimization Design for Supersonic Inlet Structure Parameter

Performance Analysis of Dual-Channel Inward-Turning Inlets under Off-Design Conditions

Aerodynamic Design Optimization by Using a Continuous Adjoint Method

Design and analysis of the mandrel structure for a composite S-shaped inlet

A nacelle inlet design approach with more three-dimensional geometric consideration

A Fast Multiobjective Optimization Approach to S-duct Scoop Inlets Design with Both Inflow and Outflow

Nacelle Inlet Optimization at High Angles of Attack Based on the Ensemble Indicator Method

Numerical simulation on aerodynamic performance of dorsal S-shaped inlet

Fast Multi-Objective Optimization Design of Gas Turbine L-inlet Duct

Surrogate Model Based Liner Optimization for Aeroengines and Comparison with Finite Elements

Finite element design sensitivity analysis and its integration with numerical optimization techniques for structural design

Wing/Engine Integrated Optimization Based on Navier-Stokes Equations

Preliminary Design on Variable-Geometry Axisymmetric Inlet Duct

A Practical Optimization Design Method for Transport Aircraft Wing/Nacelle Integration

Topology Optimization Procedure of Aircraft Mechanical Components Based on Computer-Aided Design, Multibody Dynamics, and Finite Element Analysis

The Optimum Match Design of Intake System for FSAE Racing Car

A3-D Numerical Optimization Design Method and Its Application in Axial Fans with Outlet Guide Vanes

Inverse design optimization of the compressor cascade airfoil assisted by active subspace approach

Numerical Analysis of Effect of Boundary Layer Characteristics on the Flow Field in S-shaped Inlet

Supercritical Wing Design and Optimization for Transonic Civil Airplane