Abstract:To minimize the residual welding deformation in the steel core of cruciform cross-section of conventional buckling-restrained braces (BRBs), a novel type of all-steel BRB, called Angle BRB (ABRB), has been developed. The steel core of ABRB consists of four angle steels of equal sides to form a non-welding cruciform yielding cross-section, and the outer restraint is composed of two angle steels of equal sides welded longitudinally to form a square hollow cross-section. Uniaxial quasi-static cyclic tests for four ABRB specimens were carried out to investigate the hysteretic behavior, in which the effects of boundary condition, construction of rotation restraint at the brace end, construction at the core projection, loading length, etc. are considered. The relative initial geometric imperfection in the yielding segment of the steel core specimens was measured before the tests, which shows that such imperfection can be well controlled within the limit of 1/1000. The test results indicate that the ABRB specimens with rigid connection exhibit better hysteretic performance than other specimens. The local compression-flexure failure mode is inclined to occur at the core projection for the ABRB specimens with pin connections and without rotation restraint at the brace end. The local compression-flexure failure occurs earlier when the loading length increases, which can be safely prevented by setting rotation restraint at the brace end. The seismic behavior of the ABRB specimens are analyzed and it is revealed that the ABRB specimens with rational constructions exhibit plump and stable hysteretic performance before failure, indicating good ductility and satisfactory cumulative hysteretic energy dissipation capacity, which shows that ABRB can serve as an effective passive energy dissipation device for structures.

Study on restraint stiffness of a four-angle assembled steel buckling-restrained brace

Study on Restraining Mechanism and Stiffness of a Four-Channel Assembled Steel Buckling-Restrained Brace

Bolt connection behavior and design of a four-angle assembled steel buckling-restrained brace: theoretical analysis

BOLT CONNECTION BEHAVIOR AND DESIGN OF A FOUR-ANGLE ASSEMBLED STEEL BUCKLING-RESTRAINED BRACE: NUMERICAL ANALYSIS

Numerical Investigations on Elastic Buckling and Hysteretic Behavior of Steel Angles Assembled Buckling-Restrained Braces

Experimental study on a four-angle assembled buckling-restrained brace subjected to axial compressive load

Optimal design of steel buckling-restrained braces considering stiffness and strength requirements

A New Stiffness-Strength-relationship-based Design Approach for Global Buckling Prevention of Buckling-Restrained Braces

Subassemblage Tests and Design of Steel Channels Assembled Buckling-Restrained Braces

Experimental & numerical investigation of all-steel assembled cruciform buckling-restrained braces

Cyclic experiments and global buckling design of steel-angle-assembled buckling-restrained braces

Global Buckling Prevention of Reduced-Core-length Buckling-Restrained Braces: Theoretical and Numerical Investigations

THEORETICAL STUDY ON DESIGN METHODS FOR DOUBLE RECTANGULAR TUBE ASSEMBLED BUCKLING-RESTRAINED BRACES

Theoretical and Experimental Investigation of Core-Separated Buckling-Restrained Braces

Experimental study on the seismic behavior of a novel type of all-steel buckling-restrained braces

Study on the Design Method of Buckling-Restrained Brace

Global Buckling Prevention of End Collared Buckling-Restrained Braces: Theoretical, Numerical Analyses and Design Recommendations

Uniaxial quasi-static cyclic tests on the hysteretic behavior of a novel type of all-Steel buckling-restrained brace

Theoretical and Experimental Studies of Battened Buckling-Restrained Braces

Flexural Response Of Angle Steel Bucking-Restrained Braces With Pinned Connections Considering End Rotation

Design Method of the Pinned External Integrated Buckling-Restrained Braces with Extended Core. Part II: Finite Element Numerical Verification