Abstract:Acetic acid lignin (AAL) obtained from Bagasse was used as a partial substitute of polyols for polyurethane (PU) adhesive due to the presence of reactive sites, i.e. aliphatic and aromatic hydroxyl groups, in its structure. To improve its reactivity, lignin is partly demethylated before the copolymerization with polyisocyanate. The demethylation, catalyzed by hydrobromic acid solution under heating conditions, resulted in a decrease of methoxy groups on the phenyl ring and the increase of phenolic hydroxyl groups. It is found that 120 ℃ is the preferred temperature for the demethylation resulted in a 36.5 % increase in hydroxyl content of lignin up to 5.25 mmol/g. Lignin-based polyurethane adhesives were prepared in two steps including preparing a prepolymer based on mixtures of toluene-2,4-diisocyanate (TDI) and unmodified or demethylated lignin, and then the polymerization was completed by adding polyethylene glycol (PEG). The mass ratio (1:1) of TDI: (lignin + PEG) in the compositions was here investigated. The results indicated that the presence of lignin (with and without demethylation) in polyurethane adhesives increased the glass transition temperature, Young’s modulus, and elongation at break. Particularly, the tensile strength was increased by 15–36 MPa with the addition of 10–30 wt% of lignin. Lignin with higher amount of hydroxyl groups prepared by partly demethylation is better integrated into the three-dimensional cross-linking networks of the covalent polymer as a substitute of polyols. Compared to those PU adhesives based on the raw AAL, the adhesives prepared by demethylated lignin have higher tensile strength and thermal stability. It indicates that the demethylation is effective and it is a good strategy to prepare lignin-based PU adhesive with favorable mechanical properties.

The Preparation of Solvent-Free Polyurethane Laminating Adhesive with Mixed-Polyols

Polyurethane wood adhesive from palm oil-based polyester polyol

Preparation of Contamination Free Polyurethane Adhesive Based on Biopolymer Castor Oil

Study on A Solvent-Free Pba/Co-Based Pu Adhesive for Aluminum-Plastics Compounding

Facile synthesis of polyester-polyether block copolyols for the sustainable high-performance polyurethane reactive hot melt adhesives

Study in Curing Properties of Two-Component Solvent-Free Polyurethane Adhesive

Study on an Aliphatic Polyurethane Laminating Adhesive Based on Castor Oil

Study on two component solvent free polyurethane adhesive for flexible packaging

Signally improvement of polyurethane adhesive with hydroxy-enriched lignin from bagasse

Research on synthesis and performance of solvent-free aluminum-plastic composite polyurethane adhesive

Polyurethane Adhesives Based on Oxyalkylated Kraft Lignin

Study on Synthesis and Performance of Environmentally-friendly Waterborne Polyurethane Adhesive

Preparation and Characterization of Polyol - Anionic Waterborne Polyurethane Adhesive

Preparation of starch polyols adhesive

Research on Synthesis and Property of Environmental Friendly Two-Component Polyurethane Adhesive

Synthesis and Characterization of Waterborne Polyurethane Adhesive from MDI and HDI

Polyurethane Adhesives for Wood Based on a Simple Mixture of Castor Oil and Crude Glycerin

Preparation and Properties of Advanced Materials for Bi-component Polyurethane Adhesives Containing Siloxane.

Preparation and Characterization of Waterborne Polyurethane As Shoe Adhesives

Preparation, mechanical properties of waterborne polyurethane and crosslinked polyurethane‐acrylate composite

Influence of preparation method on adhesion and drying performances of polyurethane dispersion