Abstract:Over the past two decades the use of near-/super-critical carbon dioxide has received much attention as a green alternative to organic solvents for chemical reactions, separations, and extractions because of its pressure-tunable physicochemical properties and economic advantages. However the advantages are diminished because of a relative narrow range of CO2-soluble materials. The goal of this work is to identify, design and synthesize oxygenated hydrocarbon-based CO2-soluble polymers that are able to serve as construction blocks for copolymers, dispersants, surfactants, thickeners, and chelating agents. Without concerning on the cost and the environmental persistence like fluorinated materials, the inexpensive, environmentally benign materials would significantly enhance the viability of near-/super-critical carbon dioxide-based technology. Based on both experimental heuristics and ab initio simulation results of molecular modeling (performed by Dr. Johnson's group), we proposed specific new polymer structures: poly(3-acetoxy oxetane) (PAO), poly(vinyl methoxymethyl ether) (PVMME), poly(vinyl 1-methoxyethyl ether) (PVMEE), and cellulose triacetate (CTA) oligomers. Phase behavior studies were also performed with novel CO2-philic compounds containing vinyl acetate, propylene glycol, or multiple tert-butyl groups. PAO, PVMME and PVMME were soluble in CO2, but not as soluble as poly(vinyl acetate). Oligomers of cellulose triacetate with as many as four repeat units solubilized into dense CO2 less than 14 MPa in the concentration range of 1-5 wt%. Phase behaviors of more than thirty compounds in dense CO2 were studied in this project. A new type of phase behavior for solid (at ambient temperature) CO2-philes that melt and dissolve in CO2 was detailed using a model binary mixture of β-D-maltose octaacetate and CO2. Copolymers of tetrafluoroethylene (TFE) and vinyl acetate (VAc) exhibited lower miscibility pressures than either of the homopolymers, probably due to quadradentate binding configurations with CO2. Phase behavior investigation of poly(propylene glycol) (PPG) monobutyl ether in CO2 demonstrated ether-CO2 interactions should receive as much attention as carbonyl-CO2 interactions when designing CO2-philic functional groups. 1,3,5-tri-tert-butylbenzene and tri-tert-butyl-phenol were both extraordinarily soluble in CO2, and are excellent candidates for CO2-soluble sand binders. In summary, although a new CO2 thickener was not identified, new non-fluorous CO2-soluble materials were identified that were, in general, acetate-rich with flexible chains, weak self-interactions, and multidentate interaction between CO2 and solute functional groups.

Synthesis of hydrophobic modified polyacrylamide functional materials in supercritical CO 2

A novel styrene/maleic anhydride copolymer for polymer modification by SC CO2

In Situ Polymerization of Poly(methyl Methacrylate)/clay Nanocomposites in Supercritical Carbon Dioxide

Synthesis and Phase Behavior of CO<sub>2</sub>-Soluble Hydrocarbon Copolymer: Poly(vinyl acetate-<i>alt</i>-dibutyl maleate)

Synthesis of Fluorocarbon-Modified Poly(acrylic Acid) in Supercritical Carbon Dioxide

Improvement in the water-absorbing properties of superabsorbent polymers (acrylic acid-co-acrylamide) in supercritical CO2

High molecular weight graft stabilisers for dispersion polymerisation of vinylidene fluoride in supercritical carbon dioxide: the effect of architecture

Polymerization of acrylonitrile in supercritical carbon dioxide

Preparation of Hydrophobically Modified Poly(acrylic Acid) in Supercritical Carbon Dioxide

Preparation and thickening mechanism of copolymer fluorinated thickeners in supercritical CO 2

Supported ATRP of Fluorinated Methacrylates in Supercritical Carbon Dioxide: Preparation of Scco2 Soluble Polymers with Low Catalytic Residues

Synthesis and Characterization of Fluorocarbon‐containing, Hydrophobically Associative Poly(acrylic Acid‐co‐rf‐poly(ethylene Glycol) Macromonomer)

New Insight into the Action of Supercritical Carbon Dioxide for Grafting of Maleic Anhydride Onto Isotactic Polypropylene by Reactive Extrusion

Preparation of Cross-Linked Microparticles of Poly(glycidyl Methacrylate) by Dispersion Polymerization of Glycidyl Methacrylate Using a PDMS Macromonomer As Stabilizer in Supercritical Carbon Dioxide

Dispersion Polymerizations of Methyl Methacrylate in Supercritical Carbon Dioxide with A Novel Ester End-Capped Perfluoropolyether Stabilizer

IDENTIFICATION, DESIGN AND SYNTHESIS OF OXYGENATED HYDROCARBON-BASED CO2-SOLUBLE POLYMERS FOR CHEMICAL AND PETROLEUM ENGINEERING APPLICATIONS

Synthesis of Fluorinated Diblock Copolymer by ATRP and Its Application of PAVAc Polymerization in ScCO2

Hydrophobic Properties of Thin Films of Comb-Shaped Perfluorohexylethyl Methacrylate-Polydimethylsiloxane Copolymers Deposited from Supercritical Carbon Dioxide Solutions

Synthesis and Solution Properties of Fluorocarbon-Modified Poly(N,N-Dimethylacrylamide)

Synthesis of an oligomeric thickener for supercritical carbon dioxide and its properties

Siloxane-Modified Poly(Acrylic Acid) Synthesized in Supercritical Co2