Abstract:Abstract When the fine-blanking process is used, secondary grinding or processing can be omitted because the shear surface of fine-blanking parts can achieve almost zero fracture zone requirements. The primary objective of the fine-blanking process is to reduce the fracture zone depth and die roll zone width. This study used a 2.5-mm-thick central processing unit (CPU) thermal heat spreader as an example. Finite element analysis software was employed to simulate and optimize the main eight process parameters that affect the fracture zone depth and die roll zone width after fine-blanking: the V-ring shape angle, V-ring height of the blank holder, V-ring height of the cavity, V-ring position, blank holder force, counter punch force, die clearance, and blanking velocity. Simulation analysis was conducted using the L 18 (2 1 × 3 7 ) Taguchi orthogonal array experimental combination. The simulation results of the fracture zone depth and die roll zone width were optimized and analyzed as quality objectives using Taguchi’s smaller-the-better design. The analysis results revealed that with fracture zone depth as the quality objective, 0.164 mm was the optimal value, and counter punch force made the largest contribution of 25.89%. In addition, with die roll zone width as the quality objective, the optimal value was 1.274 mm, and V-ring height of the cavity made the largest contribution of 29.45%. Subsequently, this study selected fracture zone depth and die roll zone width as multicriteria quality objectives and used the robust multicriteria optimal approach and Pareto-optimal solutions to perform multicriteria optimization analysis. The results met the industry’s fraction zone depth standard (below 12% of blank thickness) and achieved a smaller die roll zone width.

An Experimental Study for the Effect of Contact Stress of Blank Holder and Punch Velocity on Crack Ratio of Fine-Blanked Surface

Study on Measurement Method of Interior Stress Distributions in Engineering Rolled-Plates

Numerical simulation and optimization of process parameters in fineblanking process

Finite element optimization of veering factor in fine-blanking process

Investigation on Wear-Induced Edge Passivation of Fine-Blanking Punch

Numerical simulation of fine-blanking process using a mixed finite element method

An Investigation of Step-Shaped-punch Fine-Blanking Process Using Finite Element Method

An Improved Ductile Fracture Criterion for Fine-Blanking Process

Piezoelectric-Based Non-Destructive Monitoring of Contact Pressures in Fine-Blanking Process

Numerical simulation and optimization of fine-blanking process for copper alloy sheet

A Study of Fine Blanking Process by Fem Simulation

Numerical investigation of tool parameter influence on the interlock forming during flat clinching process

Failure control on hydroforming process of thin-walled aluminum alloy with complex surface covers

Influence and improvement of stamping process parameters on V-shaped clamp forming quality

Study on influencing rule of critical blank holder force of rectangular box flange wrinkling

Improvement of Die-Roll Quality in Compound Fine-Blanking Forming Process

Interaction Effect of Cracks and Anisotropic Influence on Degradation of Edge Stretchability in Hole-Expansion of Advanced High Strength Steel

Experimental Research on Critical Blank Holder Force of Rectangular Box Flange Wrinkling

Effect of blank holder force on joining quality of the flat clinch-rivet process

Ductile Damage and Simulation of Fine-Blanking Process by FEM

Numerical Study on Interface Contact Pressure During Stamping