Voluntary killer: Multivariate highway geometric factors contributing to crashes and collisions in China's mountainous regions
Yonggang Wang,Kuanmin Chen,Liwei Hu,Yulong Pei
2010-01-01
Abstract:Mountainous highway goes through complex geographic and geological regions and causes safety problem. Understanding the mechanism of crash occurrence well and providing effective safety improvement measures is a challenging task that traffic engineers and researchers have to confront. In the past decades, many studies focused on the safety issue of urban road have resulted in numerous of models and methods to quantify the safety effects of geometric, traffic variables, environmental, and human factors on the occurrence of crash at specific locations. The similar concerns on mountainous highway, however, have rarely been performed. This paper presents the details of an investigation aimed at identifying critical geometric factors contributing towards higher crash rate in mountainous highways. The objectives of this research are to (1) demonstrate the relationship that crash occurrence is associated to geometric variables in different ways, (2) inspire the insight regarding causes of occurrence and countermeasure, and (3) provide concrete proposals in improving the current Technical Standard of Highway Engineering. Based on 5426 motor vehicle crashes collected on three freeways (Jingzhu, Chengyu and Shenda) in the mountainous areas of Southeast, Southwest and Northeast China, contributory geometric factors are divided into three categories: including horizontal alignment, vertical alignment and cross section, and then detailed effects of geometric variables (e.g., radius of horizontal curve, angle of deflection, grade, radius of vertical curve, number of lanes and lane width, presence of shoulders and subgrades, etc.) are separately discussed and quantified through the relation with crash rate. Results of this study shows current standard of roadway design has not given full attention to mountainous highways, and geometric design in these regions should involve much stricter requirements of technical parameters, as proposed in this research.