Abstract:The study and prevention of unstable vibration is a challenging task for vehicle industry. Improving predicting accuracy of braking squeal model is of great concern. Closed-loop coupling disc brake model is widely used in complex eigenvalue analysis and further analysis. The coupling stiffness of disc rotor and pads is one of the most important parameters in the model. But in most studies the stiffness is calculated by simple static force-deformation simulation. In this paper, a closed-loop coupling disc brake model is built. Initial values of coupling stiffness are estimated from static calculation. Experiment modal analysis of stationary disc brake system with brake line pressure and brake torques applied is conducted. Then an optimization process is initiated to minimize the differences between modal frequencies predicted by the stationary model and those from test. Thus model parameters more close to reality are found. Unstable mode prediction results using parameters before/after optimization are compared with those from brake noise bench test. The results after parameter optimization are in good correlation with test result and illustrate obvious improvement of predicting accuracy. Finally, the presented method is used to study the relationship between the coupling stiffness and brake conditions, i.e. brake-line pressure. The result shows accordant with literature.

Vibration Characteristic Analysis and Collaborative Optimization Design for the Disk Brake

Analyzing Performance of Automobile Brake Drum in 3D Thermo-elastic Coupling Field

Modal Analysis of the Key Parts in a Disc Brake

The Vibration and Modal Analysis of the Disc Brake

Theoretical Modeling and FEA of Thermo-mechanical Coupling Dynamics of Ventilated Disc Brake

Research on dynamic characteristics of disc brake

Experimental Investigation into Friction- Vibration Coupling Characteristics of Vehicle Disc Brake

Optimization of Vehicle Disc Brakes Stability Based on Response Surface Method

On the Coupling Stiffness in Closed-Loop Coupling Disc Brake Model Through Optimization

Simulation and Analysis of Brake Judder Phenomenon by Using ADAMS

Numerical Study on the Vibration Characteristics of Automobile Brake Disk and Pad

Design and performance analysis of pneumatic disc brake of a new energy commercial vehicle

Modeling and Analysis of the Brake Torque Variation Induced by Disc Side Face Run-Out

Prediction and Optimization of the Disc Brake Squeal Performance with Altair HyperWorks and ANSYS

Improvement of Prediction Accuracy of Brake Squeal with Complex Modal FE Model

Numerical solution for vibration behavior of automotive brake disc and pads

Multidisciplinary Design Optimization for Automobile Disk Brake Based on iSIGHT

Optimization design of disc-drum brakes based on response surface method

Modal Analysis of Brake Disc and Its Application to Production-line Inspection System

Complex modal analysis model for frictional squeal of an automotive drum brake and its affect factors

Friction Modeling for Thermo-mechanical Coupling Characterization of Disc Brake