Abstract:Natural gas, known for its high combustion efficiency and low CO 2 emissions, is experiencing a significant increase in both market share and application range. Despite these advantages, there are also challenges emerged during the combustion process, including occurrence of high flame temperature, difficulty in controlling nitrogen oxide emissions, combustion instability, and a tendency to backfire. To address these issues and achieve clean and stable burning, a novel 14MW water-cooled pre-mixed burner has been developed. In-depth simulations are conducted to assess the impact of various structural and operating parameters on combustion and pollutant emission characteristics. Results indicate that the combustion temperature follows a "W" shape with height of the low cooling component while its width governs combustion stability. Gas inlet spacing influences the flame center position and anti-backfire performance. The flare angle of gas channels determines the minimum ignition energy of the mixed gas fuel which affects ignition point and flame center position. Although large height of high cooling component contributes to low NO x emissions at the gas outlet, the resultant low temperature is undesirable for combustion stability. Further examinations of operating parameters through simulations reveal that combustion temperature initially decreases and then increases with excess air coefficient, while a significant decrease is noted with lower operating load. The premixed water-cooled technology could achieve low-NO x emissions to 2.89 mg·Nm -3 with the combustion temperature controlled at 1642K. This study provides valuable data for the design of low-NO x gas burners, serving as a reference for achieving clean and stable combustion of gas fuel.

Design and Simulation of New Energy-Saving Burner

Experimental and Numerical Study of a Two-Stage Swirl Burner

TEST STUDY ON OUTLET FLOW FIELD PERFORMANCE FROM WAVE-SHAPED COMBUSTION-STABILIZING BODY OF THE CONCENTRATION TUNABLE RICH/LEAN BURNERS

Design and Optimization of Distribution Structure of Fully Premixed Surface Burner

Numerical simulation of combustion distribution in a gas burner

Numerical Simulation On Structure Optimization For Hot-Blast Stove Burner

Numerical Simulation of Influencing Factors and a Way of Optimizing Burners for Coal-bed Gas of Low Calorific Value

Simulation of temperature field of sintering ignition furnace

Numerical Simulation of the Aerodynamic Field of a New Type Bluff Body Steady Burner

Numerical Simulation on Optimum Design of Regenerative Burner

The Structural Design of and Experimental Research on a Coke Oven Gas Burner

Investigation of NOx emission under different burner structures with the optimized combustion model

Modeling and Simulation of Combustion Chamber

Experimental Study And Numerical Simulation On A Novel Structure Of Dual Register Whirl Burner

Experiment and numerical study on combustion characteristics of low-nitrogen burners

Numerical Simulation and Experimental Study on A Novel Kiln Burner

Study of the Structural Optimization of a Partially Pre-mixed Type Swirling Burner Burning the Coal Bed Gas With a Low Heat Value

Numerical Investigation of Different Burner Arrangement on A Coal-Fired Boiler

Optimization Design in a Baking Furnace Based on CFD

A Numerical Simulation of a Low-heat-value Coal-bed Gas Burner

Numerical Studies of a Water-cooled Premixed Burner for Low NO x Combustion of Natural Gas