Abstract:High power continuous-wave (CW) single-frequency 1342 nm lasers are of interest for fundamental research, particularly, for laser cooling of lithium atoms. Using the popular Nd:YVO4 laser crystal requires careful heat management, because strong thermal effects in the gain medium are the most severe limitations of output power. Here, we present a multi-segmented Nd:YVO4 crystal design that consists of three segments with successive doping concentrations, optimized using a theoretical model. In order to quantify the optimization, we measured the thermal lens power of conventional crystal designs and compare them to our multi-segmented design. The optimized design displays a two times lower thermal lens dioptric power for the same amount of absorbed pump power in the non-lasing case. Using the optimized design, we demonstrate a high power all-solid-state laser emitting 10.0 W single-frequency radiation at 1342 nm when operating the laser crystal at room temperature. Further integration of the laser allows us to operate the laser crystal below room temperature for improving output power up to 11.4 W at 8°C. This is explained by the reduction of energy-transfer upconversion and excited-state absorption effects. Stable free-running operation at the low temperature of 8 °C is achieved with the power stability of ± 0.42 % by peak-to-peak fluctuation and frequency peak-to-peak fluctuation of ± 72 MHz in three hours.

Local-cooled watt-level Nd-doped phosphate single-mode fiber laser

Fiber-solid, Hybrid, Single-Frequency Laser (100 W) with a 100 MHz Repetition Rate and 1 Ns Pulse Width from a Spherical Aberration Compensated Four-Stage Nd:YVO4 Amplifier

Efficient Generation of Watt-Level Output from Short-Length Nd-Doped Phosphate Fiber Lasers

Efficient laser operation with low loss Nd3+-doped phosphate glass fiber under direct pumping

Nd-doped phosphate glass microstructured optical fiber laser

Efficient three-level continuous-wave and GHz passively mode-locked laser by a Nd3+-doped silicate glass single mode fiber

1386 nm continuous wave output from laser diode end-pumped 1386 nm Nd:YVO4 laser

400 Mw Ultrashort Cavity Low-Noise Single-Frequency Yb^3+-doped Phosphate Fiber Laser

220 W Raman Fiber Laser at 1.24 Μm Based on Phosphosilicate Fiber

400 mW ultrashort cavity low-noise single-frequency Yb³⁺-doped phosphate fiber laser.

1010 nm Directly LD-Pumped 6kW Monolithic Fiber Laser Employing Long-Tapered Yb3+-Doped Fiber

High-efficiency longwave 2085 nm laser output in low-loss Ho 3+ -doped fluorotellurite glass fiber by 1976 nm in-band pumping

Phase Locking of A Compact Nd-Doped Phosphate Multicore Fiber Laser

Three-level all-fiber laser at 915 nm based on polarization-maintaining Nd<SUP>3+</SUP>-doped silica fiber

11-Watt Single-Frequency 1342-Nm Laser Based on Multi-Segmented Nd:YVO 4 Crystal

115-Mhz Linear NPE Fiber Laser Using All Polarization-Maintaining Fibers

Continous-wave and passively Q-switched laser at 1.36 μm of a Nd^3+-doped phosphate fiber with a Yb^3+-doped inner cladding

Large-mode-area Nd-doped anti-resonant phosphate fiber for high-power single-mode 900 nm laser generation

Yb-Doped Aluminophosphosilicate Laser Fiber

Ultrafast Fiber Laser at 0.9 Μm with a Gigahertz Fundamental Repetition Rate by a High Gain Nd3+-doped Phosphate Glass Fiber.

Study on π-polarized 1084 nm CW laser based on Nd3+ doped MgO:LiNbO3 with the end-face double-focus coupling pumping mode