Effects of aspect ratio on the drag of a wall-mounted finite-length cylinder in subcritical and critical regimes

H. F. Wang,Y. Zhou,J. Mi

DOI: https://doi.org/10.1007/s00348-012-1299-z

IF: 2.797

2012-01-01

Experiments in Fluids

Abstract:The effect of cylinder aspect ratio (≡ H / d , where H is the cylinder height or length, and d is the cylinder diameter) on the drag of a wall-mounted finite-length circular cylinder in both subcritical and critical regimes is experimentally investigated. Two cases are considered: a smooth cylinder submerged in a turbulent boundary layer and a roughened cylinder immersed in a laminar uniform flow. In the former case, the Reynolds number Re d (≡ U ∞ d / ν , with U ∞ being the free-stream velocity and ν the fluid viscosity) was varied from 2.61 × 10 4 to 2.87 × 10 5 , and two values of H / d (2.65 and 5) were examined; in the latter case, Re d = 1.24 × 10 4 –1.73 × 10 5 and H / d = 3, 5 and 7. In the subcritical regime, both the drag coefficient C D and the Strouhal number St are smaller than their counterparts for a two-dimensional cylinder and reduce monotonously with decreasing H / d . The presence of a turbulent boundary layer causes an early transition from the subcritical to critical regime and considerably enlarges the Re d range of the critical regime. No laminar separation bubble occurs on the finite-length cylinder immersed in the turbulent boundary layer, and consequently, the discontinuity is not observed in the C D – Re d and St – Re d curves. In the roughened cylinder case, the Re d range of the critical regime grows gradually with decreasing H / d , while the C D crisis becomes less obvious. In both cases, H / d has a negligible effect on the critical value of Re d at which transition occurs from the subcritical to critical regime.