Abstract:Heat transfer model is the basis for control and optimization of continuous casting of steel. In this paper, a three dimensional (3D) real-time heat transfer model has been presented for continuous casting blooms, especially for the initial and final casting stages. To be real-time, an algorithm based on inheritable variable non-uniform grid and variable time steps has been developed, accelerating the 3D heat transfer model by 110-200 times. Meanwhile, the discrete parameters including grid and time step have been optimized, and the influence of central processing units (CPUs) and programming languages has also been studied. Then the relative calculation time, which is the ratio of calculation time to physical time, has been reduced to 0.62 while numerical errors are within 0.74%. Further, to reduce the uncertainty of the model, the machine-dependent parameters appearing in the thermo-physical properties and the boundary conditions have been calibrated with measurements of surface temperature by thermometer and shell-thickness by nail-shooting, then the corresponding optimization problem of minimizing the errors between calculation and measurements has been solved by particle swarm optimization algorithm. After calibration, the model's uncertainty has been obviously reduced. Finally, the calibrated model has been verified by online surface temperature measurement and it shows good agreement as the errors between calculation and measurements are less than +/- 10 degrees C.

Crystallizer'S Heat-Transferring Theory Analysis and Thermal Field Simulation

Numerical Prediction of Turbulent Flow and Heat Transfer with Phase Change in Crystallizer of Inverse Casting

Complex Heat Transfer Model in an Electroslag Remelting Mold

Mathematical Model and Numerical Simulation of Turbulent Flow, Heat Transfer and Solidification in a Crystallizor of Inverse Casting

Advance in Mathematic Model of Solidification Heat Transfer Process in Continuous Casting

The Numerical Simulation for the Thermal Process of Continuous Cast of CSP

Computational Modeling of Temperature, Flow, and Crystallization of Mold Slag During Double Hot Thermocouple Technique Experiments

Modeling And Simulating For The Temperature Field In Casting Tip During Continuous Roll Casting

Numerical Simulation of Heat Transfer and Solidification of Electromagnetic Continuous Casting Round Billet Considering Gap

The effect of in-situ dynamic mold flux melting and crystallization on heat transfer in continuous casting

Mathematical Modeling of Thermal Resistances of Mold Flux and Air Gap in Continuous Casting Mold Based on an Inverse Problem

Analysis of heat transfer and thermal stress in continuous casting with mechanical reduction

Effect of mold flux melting and crystal fraction dissolution on radiative heat transfer in continuous casting

A Complete Thermal Analysis of a Funnel-Type Mold Used in High-Speed Thin Slab Continuous Casting Through Three-Dimensional Inverse Heat Conduction Problem

Numerical Simulation of Continuous Casting During Solidification and Heart-transferring Process

Mathematical Model for Turbulent Flow, Heat Transfer, and Solidification

3D Transient Heat Transfer Simulation and Optimization for Initial Stage of Steel Continuous Casting Process

The Simulation Analysis on the Heat Transfer Model of Bloom

The Observation of Mold Flux Crystallization on Radiative Heat Transfer

A Three Dimensional Real-time Heat Transfer Model for Continuous Casting Blooms

Simulation Of Heat Transfer In Slab Continuous Casting Mold And New Formation Mechanism Of Shell Hot Spots