Abstract:Separated gravity heat pipes, with distinct arrangements of evaporating and condensing sections, offer low thermal resistance, high heat transfer efficiency, and a simple structure, making them suitable for passive cooling of spent fuel pools through gravity-driven processes. In this study, a steady-state, one-dimensional, two-phase flow model is developed to analyze phase change heat transfer in a separated gravity heat pipe. The research investigates the impact of liquid filling rate and vacuum level on heat pipe operation. The findings reveal a notable increase in pressure drop inside the tube with higher liquid filling rates, which diminishes the adaptability of the heat pipe as pressure rises, resulting in a narrower range of effective liquid filling rates. Specifically, the liquid filling rate of the heat pipe ranges from 38 % to 72 % at P =13.75 kPa and from 44 % to 68 % at P = 15.75 kPa. Additionally, a startup prediction model is formulated based on a thermal resistance network model using the ideal gas assumption. Two startup states-namely, the initial startup state and the subsequent startup state-are proposed for large-scale separated gravity heat pipe arrays. The heat pipe achieves the largetemperature-difference initial startup state at a 50 % liquid filling rate within 7 min before transitioning to the subsequent startup state. The vapor mass, heat transfer coefficient, and working fluid temperature initially increase and then decrease over time, with varying peak times. As the liquid filling rate increases, the maximum vapor mass also increases. The heat transfer coefficient peaks at a 60 % liquid filling rate before subsequently declining. The optimal liquid filling rate of 60 % is identified based on startup time, heat transfer coefficient, and overall heat transfer efficiency.

Experimental studies to heat transfer characteristics of separated heat pipes

Experimental Investigation on the Temperature Distribution Characteristics of the Evaporation Section in a Pulsating Heat Pipe

Theoretical and Experimental Research on Heat Transfer Performance of the Semi-Open Heat Pipe

Two Phase Flow and Heat Transfer Characteristics of a Separate-Type Heat Pipe

Experimental Investigation on Performance of Separation Heat Pipe Using R22 as Working Liquid at Low Heat Flux

Visualization experiment on boiling heat transfer and flow characteristics in separated heat pipe system

Numerical Research on Heat Transfer Characteristics of Evaporation Segment of Separate Type Heat Pipe

Experimental investigation of heat transfer characteristics of small spiral-tube evaporating section in a segregation-type heat pipe

An experimental investigation on the thermal performance of a flat plate heat pipe spreader

Experimental Investigation on Heat Transfer of Microchannel Separate Heat Pipe

Experimental comparison and numerical study of flow and heat transfer characteristics of the pipe rows in heat pipe heat exchanger

Experiment Investigation on Heat Transfer Characteristics of A Novel Gravity-Assisted Heat Pipe Heat Exchanger

Theoretical and Experimental Study on Heat Transfer Characteristics of Water Heat Pipe

Experimental Study of the Heat Transfer Performance of a T-shaped Fin Boiling Intensified Heat Exchange Pipe

Experimental Study on the Influence of Initial State Parameters on the Start-Up and Heat Transfer Characteristics of Separated Heat Pipe System

Experimental Research and Simulation in a Thermosyphon

Heat Transfer Performance and Startup Characteristics of Separated Gravity Heat Pipe

Experimental investigation on thermal characteristics of flat miniature axially grooved heat pipes

Heat Transfer Performance in 3D Internally Finned Heat Pipe

Modeling and Analysis of Two-Phase Distribution in Large-Scale Separate Heat Pipe

Heat transfer performance on unequal-diameter pulsating heat pipe