Abstract:A comprehensive model based on the Navier–Stokes equation and particle tracking method is used to study the effervescent atomization impinging spray, and another model is used to establish the relationship between the droplet velocity near the plate and the different operating conditions. The models and numerical code are validated by comparing the numerical results with the published experimental results. The effects of air-to-liquid ratio, nozzle diameter, liquid mass flow rate, and the position of impinging plate on the Weber number and K number as well as the droplet deposition onto the plate are discussed. The results show that the droplet velocity near the plate increases with increasing air-to-liquid ratio and liquid mass flow rate, and with decreasing nozzle diameter and axial distance from the nozzle exit to the plate. The droplet diameter near the plate increases with increasing axial distance from the nozzle exit to the plate, and with decreasing air-to-liquid ratio. As a function of the nozzle diameter and liquid mass flow rate, the variation of droplet diameter is not monotonous and the effect of liquid mass flow rate on the droplet diameter is insignificant. In the studied operating conditions, it is difficult for the droplet to rebound off the plate when impinging on the plate but it is easier for the droplet to splash. In order to create a condition which can benefit the droplet deposition when impinging on the plate, the suggested ways are to reduce the air-to-liquid ratio and liquid mass flow rate, increase the nozzle diameter, and select a suitable range of axial distance from the nozzle exit to the plate.

Theoretical Model Study on Impact Heat Transfer Between Particles in Impinging Streams

Thin liquid film flow and heat transfer under spray impingement

Heat Transfer of Batch Simulating Continuous Fluidized Bed with Wet Particles

Hydrodynamics and Heat Transfer in a Fluidized Bed with Liquid Spray: Particle Color-Change Based Measurement and Modelling

Simulation of Droplet Impact, Transforming and Solidification on Different Substrates Using ISPH Method

Effects of operating conditions on droplet deposition onto surface of atomization impinging spray

Mechanics of enhancement of convective heat transfer due to particle impact in gas-solid two-phase flow

Analytical Consideration of Liquid Droplet Impingement on Solid Surfaces

Simulation of Droplet-gas Flow in the Effervescent Atomization Spray with an Impinging Plate

Theoretical Analysis and Modeling of Overall Heat Transfer of Air Handling Unit by Using Spraying Water

Numerical Investigation of the Flow Dynamics and Evaporative Cooling of Water Droplets Impinging Onto Heated Surfaces: an Effective Approach to Identify Spray Cooling Mechanisms

Numerical study on coupled multiphase thermal and mass transfer of moving surface impacted by jet array in semi-enclosed space

Experimental study of two-phase heat transfer of droplet impact on liquid film

Numerical investigation of Weber number and gravity effects on fluid flow and heat transfer of successive droplets impacting liquid film

Study of the drying characteristics in an asymmetric impinging stream reactor

Numerical investigation on the thermal-flow performance of humid air-water in the interspace outside staggered tube bundles

Heat transfer of tubes in gas-solid cross flow

Numerical simulation of the drying characteristics of a high-moisture particle in a dynamic asymmetric impinging stream reactor

Effect of Particle Loading on Heat Transfer Enhancement in a Gas-Solid Suspension Cross Flow

Three-dimensional Simulation on Liquid Film Vaporization in the Process of Spray Impingement

Interfacial phenomena and heat transfer associated with multi-droplet impact on flowing liquid film