Simulation And Optimization Of Giant Radial Tire Vulcanization Process

Youshan Wang,Benlong Su,Jian Wu

DOI: https://doi.org/10.1016/j.proeng.2012.01.1092

2012-01-01

Abstract:The process of curing a pneumatic tire as one of the most important working procedures, directly identify the quality of tire, because the physical and mechanical properties of rubber in the state of overcure or undercure are significantly decreased. The finite element analysis (FEA) method was introduced to evaluate the tire's state of cure (SOC) in this paper, and the optimization of cure conditions of giant radial tire was also referred to ensure that tire constituents achieved the proper SOC and improved the quality of tire. Results indicated that when the cure time was cut down 35 minutes by optimization process, most part of tire compound is appropriate cured. So that the energy cost was remarkable cut down and the productivity was rising in evidence. (C) 2011 Published by Elsevier Ltd. Selection and/or peer-review under responsibility of Kunming University of Science and Technology