Abstract:In the measurement of plate specimens, traditional two-dimensional (2D) digital image correlation (DIC) is challenged by two aspects: (1) the slant optical axis (misalignment of the optical camera axis and the object surface) and (2) out-of-plane motions (including translations and rotations) of the specimens. There are measurement errors in the results measured by 2D DIC, especially when the out-of-plane motions are big enough. To solve this problem, a novel compensation method has been proposed to correct the unsatisfactory results. The proposed compensation method consists of three main parts: 1) a pre-calibration step is used to determine the intrinsic parameters and lens distortions; 2) a compensation panel (a rigid panel with several markers located at known positions) is mounted to the specimen to track the specimen's motion so that the relative coordinate transformation between the compensation panel and the 2D DIC setup can be calculated using the coordinate transform algorithm; 3) three-dimensional world coordinates of measuring points on the specimen can be reconstructed via the coordinate transform algorithm and used to calculate deformations. Simulations have been carried out to validate the proposed compensation method. Results come out that when the extensometer length is 400 pixels, the strain accuracy reaches 10 la no matter out-of-plane translations (less than 1/200 of the object distance) nor out of-plane rotations (rotation angle less than 5) occur. The proposed compensation method leads to good results even when the out-of-plane translation reaches several percents of the object distance or the out-of-plane rotation angle reaches tens of degrees. The proposed compensation method has been applied in tensile experiments to obtain high-accuracy results as well. (C) 2017 Published by Elsevier Ltd.

Displacement Amplifier Design For An Extensometer In High Temperature Deformation Monitoring

The Analysis of Temperature Effect and Temperature Compensation of Moems Accelerometer Based on A Grating Interferometric Cavity

Determination of Thermally Induced Effects and Design Guidelines of Optomechanical Accelerometers

High Temperature Eddy Current Displacement Sensor Based on Temperature Drift Compensation

Enhanced Sensitivity and Robustness in an Embeddable Strain Sensor Using Microwave Resonators

Thermo-electro-mechanical Synergistic Effect on the Actuation Performance of Piezoelectric Stack

An Optoelectronic Oscillator‐based Strain Sensor with Extended Measurement Range

Design and analysis of a piezo-actuated hydraulic micro-displacement amplifier with high bandwidth and large amplification ratio

Dynamic large strain measurement under high-temperature environment using a modified FBG sensor and plasma surface treatment

An embeddable optical strain gauge based on a buckled beam

Analysis and optimal design a new flexible hinge displacement amplifier mechanism by using Finite element analysis based on Taguchi method

Measurements for Displacement and Deformation at High Temperature by Using Edge Detection of Digital Image.

Study on the High Temperature Deformation Measurement Using the Mark Shearing Technique

Displacement Loss Of Flexure-Hinged Amplifying Mechanism

Design of a high temperature resistant instrument amplifier using high temperature gain self-calibration technology

High-accuracy Optical Extensometer Based on Coordinate Transform in Two-Dimensional Digital Image Correlation

RESEARCH ON THE METHOD OF MEASURING LONG-TERM DEFORMATION IN A SMALL REGION AT HIGH TEMPERATURE AND ITS APPLICATION

High-accurate two-dimensional digital image real-time extensometer

Enhanced Thermal Expansion by Micro-Displacement Amplifying Mechanical Metamaterial

Temperature compensation high strain measure ment based on a Fabry-Perot interferometer with the virtual-assisted Vernier effect

Single-Ended Eddy Current Micro-Displacement Sensor with High Precision Based on Temperature Compensation