Effect of post-weld heat treatment on the microstructure and properties of titanium/304 stainless steel laser welding dissimilar metal joints with copper as the transition layer
Yun-long Li,Hong-shuang Di,Xiao-nan Wang,Li-qing Chen,Tian-xiang Li
DOI: https://doi.org/10.1016/j.mtcomm.2023.106593
IF: 3.8
2023-07-06
Materials Today Communications
Abstract:Low elongation has been an important factor limiting the application of titanium/304 stainless steel (304SS) laser welding of dissimilar metal joint products. By adopting the post-weld heat treatment (PWHT) process of holding the welded joint at 400 °C, 550 °C and 700 °C for 30 min, this study increases the elongation of the welded joint from 0.3 % to 2.21 % in the welded state and further analyses and investigates the structural changes in the organization and the formation process of intermetallic compounds (IMC) within the weld seam. The results showed that the acicular structure in the weld could not be eliminated by holding at 400 °C for 30 min, but only part of the residual stress was released, and the elongation was increased to 0.85 %. After holding at 550 °C for 30 min, a large number of equiaxed crystals appeared to replace the acicular structure in the weld and released the residual stress. With the enhancement of the IMC layer thickness, grain gap and deformation coordination ability, the elongation increased to 2.21 %. After holding at 700 °C for half an hour, the IMC layer becomes thinner, the grain gap decreases, the deformation coordination ability deteriorates, and the tensile strength and elongation decrease. In the tensile test, the fracture position was all at the weld. After being held at 400 °C for 30 min, the average tensile strength of the tensile sample increased from 330 MPa in the welded state to 352 MPa; after being held at 550 °C for 30 min, the average tensile strength of the tensile sample was 340 MPa, and the fracture elongation was 7.4 times that of the welded state, reaching 331 μm.
materials science, multidisciplinary