Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Temperature Distribution of Heat Transfer Surface in Spray Cooling with Ammonia

Experimental Investigation of Spray Cooling Performance in Non‐boiling Zone on Rough Superhydrophilic/hydrophobic Surfaces

Experimental Study on a Spray and Falling-Film Cooling System

Transient heat transfer characteristics in spray cooling

Thermal-hydraulic Performance of Ammonia in Manifold Microchannel Heat Sink

Experimental Investigation on Heat Transfer Characteristics of Liquid Nitrogen Spray Cooling for Large Area

Wetting layer evolution and interfacial heat transfer in water-air spray cooling process of hot metallic surface

Experimental Study on Temperature Variation Patterns and Deterioration of Spray Cooling with R21

Coupling dynamic thermal analysis and surface modification to enhance heat dissipation of R410A spray cooling for high-power electronics

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Visualization Study on Atomization Characteristics and Heat Transfer Performance of R1336mzz Flash Spray Cooling

Numerical investigation on heat transfer enhancement and surface temperature non-uniformity improvement of spray cooling

Numerical Investigations of the Cooling Performance of an R410A Closed-Loop Spray Cooling System

Experimental investigation on heat transfer of spray cooling with isobutane (R600a)

Experimental Investigation on Heat Transfer Characteristics of R1336mzz Flash Spray Cooling

Experimental Study on Heat Transfer Performance Using a Hybrid Cooling Method Combined of a Flat-Plate Heat Pipe and Spray Cooling

Parametric study of water spray cooling on enhanced relatively large surfaces

Experimental study on heat transfer and power consumption of low-pressure spray cooling

Experimental Investigation of Spray Cooling on Micro-, Nano- and Hybrid-Structured Surfaces

Investigation on heat transfer characteristics of R134a spray cooling

Simulation Study on Temperature and Stress and Deformation on Encapsulated Surfaces under Spray Cooling