High Thermoelectric Performance in Rhombohedral GeSe-LiBiTe2
Jinfeng Dong,Yukun Liu,Zhi Li,Hongyao Xie,Yilin Jiang,Honghui Wang,Xian Yi Tan,Ady Suwardi,Xiaoyuan Zhou,Jing-Feng Li,Christopher Wolverton,Vinayak P. Dravid,Qingyu Yan,Mercouri G. Kanatzidis
DOI: https://doi.org/10.1021/jacs.4c04453
IF: 15
2024-01-01
Journal of the American Chemical Society
Abstract:GeSe, an analogue of SnSe, shows promise in exhibiting exceptional thermoelectric performance in the Pnma phase. The constraints on its dopability, however, pose challenges in attaining optimal carrier concentrations and improving ZT values. This study demonstrates a crystal structure evolution strategy for achieving highly doped samples and promising ZTs in GeSe via LiBiTe2 alloying. A rhombohedral phase (R3m) can be stabilized in the GeSe-LiBiTe2 system, further evolving into a cubic (Fm3m) phase with a rising temperature. The band structures of GeSe-LiBiTe2 in the rhombohedral and cubic phases feature a similar multiple-valley energy-converged valence band of L and Sigma bands. The observed high carrier concentration (similar to 10(20) cm(-3)) reflects the effective convergence of these bands, enabling a high density-of-states effective mass and an enhanced power factor. Moreover, a very low lattice thermal conductivity of 0.6-0.5 W m(-1) K-1 from 300 to 723 K is achieved in 0.9GeSe-0.1LiBiTe(2), approaching the amorphous limit value. This remarkably low lattice thermal conductivity is related to phonon scattering from point defects, planar vacancies, and ferroelectric instability-induced low-energy Einstein oscillators. Finally, a maximum ZT value of 1.1 to 1.3 at 723 K is obtained, with a high average ZT value of over 0.8 (400-723 K) in 0.9GeSe-0.1LiBiTe(2) samples. This study establishes a viable route for tailoring crystal structures to significantly improve the performance of GeSe-related compounds.