Abstract:Multi-level dual-active-bridge (DAB) DC-DC converters offer higher voltage-blocking capability and larger stepup ratios, as well as increased number of degrees of freedom (DoFs) compared to the traditional two-level DAB converter. Thus, it has potential to be used in medium-voltage DC (MVDC) systems. However, the control complexity of the multi-level DAB converters also increases along with the number of DoFs. When soft-switching is considered as an optimization objective together with other performance indices (e.g., peak or root-mean-square values of the inductor current), the analytical solutions will be difficult to derive due to the increased number of control variables and complicated soft-switching constraints. To address this issue and improve the efficiency of the DAB converter, this paper proposes a control strategy for a multi-level DAB converter to achieve both soft-switching and minimum current stress simultaneously. The analytical solutions are calculated by improved Karush-Kuhn-Tucker (KKT) conditions, where the numerical solutions are used to locate the operating modes and determine the zero-voltage-switching (ZVS) boundaries. This can simplify the Lagrangian function and inequality constraints, and then, the analytical solutions can be obtained by the simplified KKT conditions. In addition, a comprehensive comparison between the quasi-ZVS and strict-ZVS control is carried out, so that the converter efficiency, implementation complexity, and smooth transition between different power levels can be compromised for practical applications. Finally, the performances of the proposed control strategy in terms of current stress minimization and softswitching operation are validated by experimental tests.

An adaptive dead-time control scheme for high-switching-frequency dual-active-bridge converter

A GaN-based MHz Active Clamp Flyback Converter with Adaptive Dual Edge Dead Time Modulation for AC-DC Adapters.

ZVS Operation of DAB Converter Based on Triple-Phase-shift Modulation Scheme with Optimized Inductor Current

Wide-Load Range Multiobjective Efficiency Optimization Produces Closed-Form Control Solutions for Dual Active Bridge Converter

Fractional-order Time Delay Compensation in Deadbeat Control for Power Converters

Integrated Optimization of Dual-Active-Bridge DC–DC Converter with ZVS for Battery Charging Applications

Optimal Control of Multi-Level DAB Converters for Soft-Switching and Minimum Current Stress

Deadbeat Current Controller for Bidirectional Dual-Active-Bridge Converter Using an Enhanced SPS Modulation Method

Active-Clamp ZVZCS Resonant Forward DC Transformer (DCX) with Load-Adaptive ON-Time Control

Dynamic Enhancement for Dual Active Bridge Converter with a Deadbeat Current Controller

Influence of Junction-Capacitance and Dead-Time on Dual-Active-Bridge Actual Soft-Switching-Range: Analytic Analysis and Solution

Optimization design of dead time in the four-switch buck-boost LLC resonant converter

An Improved Dual Active Bridge DC/DC Converter

ZVS Control Strategy of Dual Active Bridge DC/DC Converter with Triple-Phase-shift Modulation Considering RMS Current Optimization

Accurate Frequency‐domain Analysis and Hybrid Control Method for Isolated Dual Active Bridge Series Resonant DC/DC Converters

Phase-shift-control system with adaptive dead-time regulation for ZVZC soft-switching inverter arc welding power supply

New methods to reduce circulating energy in dual active bridge converter

Optimal Control Scheme for Single-Stage Dual-Active-Bridge AC-DC Converter

Extension of Zero-Voltage Switching Region of Wide Volage Ratio Range Dual-Active-Bridge Converter by LC Antiresonant Network

Dead-Time Effect of the High-Frequency Isolated Bidirectional Full-Bridge DC–DC Converter: Comprehensive Theoretical Analysis and Experimental Verification