Abstract:Gas or liquid flow through small channels has become more and more popular due to the micro-electromechanical systems (MEMS) fabrication technologies such as micro-motors, electrostatic comb-drive, micro-chromatographs, micro-actuators, micro-turbines and micro-pumps, etc. The flow conditions in and around these systems are always recognized as typical transitional regimes. Under these conditions, the mean free path of gas molecules approaches the characteristic scale of the micro-devices itself, and due to the little collisions the heat and momentum cannot equilibrate between the wall and fluids quickly. Couette flow is a simple and critical model in fluid dynamics which focuses on the mechanism of the heat transfer in shear-driven micro-cavities or micro-channels. Despite numerous work on the numerical solutions of the Couette flow, how to propose stable and accurate slip boundary conditions in rarefied flow conditions still remains to be elucidated. In this paper, converged solutions for steady-state micro Couette flows are obtained by using conventional Burnett equations with a set of modified slip boundary conditions. Instead of using the physical variables at the wall, the modified slip conditions use the variables at the edge of the Knudsen layer based on a physically plausible assumption in literature that Knudsen layer has a thickness only in the order of a mean free path and molecules are likely to travel without collision in this layer. Numerical results for non-dimensional wall shear stress and heat flux are compared with those of the DSMC solutions. Although there are not much improvement in the accuracy by using this modified slip conditions, the modified conditions perform much better than the unmodified slip conditions for numerical stabilization. All results show that the set of conventional Burnett equations with second order modified conditions are proved to be an appropriate model for the micro-Couette flows.

CFD Simulation on Circulation Within the Liquid Slug under Gas-Liquid Taylor Flow in Circular Capillary

CFD simulation of bubble column with vertical bundle internals

CFD Simulation of Gas-Liquid Flow in Bubble Column

CFD Simulation for Up Flow Jet-Loop Reactors by Use of Bi-Dispersed Bubble Model

Experiment and Numerical Simulation on Slug Fluidization of Geldart D Particles

A Dual-Scale Turbulence Model for Gas–liquid Bubbly Flows

CFD simulation of effects of the configuration of gas distributors on gas–liquid flow and mixing in a bubble column

Influence of Short-Draft Tube on Fluid Dynamics in Bubble Column with CFD

Application of CFD Simulation for Optimisation of the Multi-Pipe Gas Distributors in a Large-Scale Shallow Bubble Column

Simulation of Couette Flow Using Conventional Burnett Equations with Modified Slip Boundary Conditions

Online Parameters Measurement of Taylor Flow in Small Channels Using Optical Technique

CFD Simulation of Gas-Liquid Flow in Bubble Column with Two-bubble Phase Population Balance Model

Evolution and Interaction Characteristics of Liquid Flow and Bubbles in a Jet Bubbling Column

Numerical Investigation on Heat Transfer and Hydrodynamic Characteristics of Gas-Liquid Taylor Flow in Capillaries

Experimental study of Taylor bubble flow in non-Newtonian liquid in a rectangular microchannel

Bubble and frictional characteristics of gas-liquid Taylor flow in capillary tube

On the three-dimensional features of a confined slug bubble in a flowing square capillary

Numerical Simulation of Taylor Flow in Micro Circular Tubes

Study of the Pressure Drop of Liquid–Liquid Slug Flow in a Circular Microchannel

Numerical Simulations of the Effect of Liquid Viscosity on Gas-Liquid Mass Transfer of a Bubble Column with a CFD-PBM Coupled Model

2D and 3d Simulations of Fluid Dynamics in the Bubble Reactor for Liquid Fuel Synthesis: Comparisons Against Experiments