Abstract:In this study, a new casing process named expendable pattern shell casting process with vacuum and low pressure (EPSC-VL) was introduced to produce complicated and thin-walled aluminum alloy castings. The gas flowrate is one of the most important process parameters for manufacturing castings during the EPSC-VL process. In the present work, the influence of gas flowrate on the filling ability and internal quality of A356 aluminum alloy castings fabricated by the EPSC-VL process were investigated. Moreover, the filling ability, internal quality, as well as mechanical properties of A356 aluminum alloy castings obtained by EPSC-VL and lost foam casting (LFC) processes were also compared. The results obtained suggested that the filling length increased with the increase of gas flowrate, and the filling length of the thick section was larger than that of the thin section under the same gas flowrate when the gas flowrate was less than 19 m(3)/h. Furthermore, the porosity of castings decreased with increasing gas flowrate, and the microstructure of castings became denser, and the internal quality of castings was obviously improved. The comparison experiments showed that the EPSC-VL process had superior filling ability, internal quality, and mechanical properties compared with the LFC process, and the surface quality of castings obtained by EPSC-VL process was also better than that of the LFC process. The casting practice of complicated and thin-walled A356 aluminum alloy intake manifold part also suggested that the EPSC-VL process had an obvious advantage for the fabrication of complicated and thin-walled aluminum alloy castings compared with the LFC process.

Influence of Vibration on the Heat Transfer of Lost Foam Casting Filling

Research on Microstructures Modification of AZ91 Mg Alloy Based on Lost Foam Casting

Effects of superimposed high-frequency vibration on deformation of aluminum in micro/meso-scale upsetting

Study on mold filling velocity in AZ91 magnesium alloy LFC process with vacuum

Numerical Simulation of Lost-Foam Casting for Key Components of A356 Aluminum Alloy in New Energy Vehicles

Effect of vibration on interfacial microstructure and mechanical properties of Mg/Al bimetal prepared by a novel compound casting

Numerical Study and Experimental Verification on Solidification Characteristics in Commercial Purity Aluminum under Mechanical Vibration

Experimental Study on the Filling Process of the Lost Foam Casting Process of a Cast Iron Plate

Study on Filling Flow of Centrifugal Casting AZ91D Alloy

Influence of Gas Flowrate on Filling Ability and Internal Quality of A356 Aluminum Alloy Castings Fabricated Using the Expendable Pattern Shell Casting with Vacuum and Low Pressure

Porosity of aluminum alloy in lost foam casting process

Influence of Process Parameters on Filling Ability of A356 Aluminium Alloy in Expendable Pattern Shell Casting with Vacuum and Low Pressure

Mass Transfer of Lost Foam Casting and Its Influence on the Casting Quality

Numerical simulation of die casting and vacuum die casting for magnesium alloy AZ91D

Comparison of NVH Performance of Magnesium Alloy Casting and Aluminium Alloy Casting

Effects of Process Parameters on Internal Quality of Castings During Novel Casting

Mold filling velocity during investment casting

Effect of Depressurizing Speed on Mold Filling Behavior and Entrainment of Oxide Film in Vacuum Suction Casting of A356 Alloy

Effects of Hollow Sand Mold on the Microstructure and Mechanical Properties of a Low Pressure Aluminum Alloy Casting

Effect of Vacuum Degree on Quality of Magnesium Alloy by Low-Pressure Expendable Pattern Casting

Investigation of the influence of vibration on the processes of porous magnesium products formation