Abstract:Carbon-coated olivine-structured LiFe 0.5 Co 0.5 PO 4 solid solution was synthesized by a facile rheological phase method and applied as cathode materials of lithium-ion batteries. The nanostructure’s properties, such as morphology, component, and crystal structure for the samples, characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), Brunauer, Emmett, and Teller (BET) determination, X-ray photoelectron spectroscopy (XPS), and the electrochemical performances were evaluated using constant current charge/discharge tests and electrochemical impedance spectroscopy (EIS). The results indicate that nanoplatelet- and nanorod-structured LiFe 0.5 Co 0.5 PO 4 /C composites were separately obtained using stearic acid or polyethylene glycol 400 (PEG400) as carbon source, and the surfaces of particles for the two samples are ideally covered by full and uniform carbon layer, which is beneficial to improving the electrochemical behaviors. Electrochemical tests verify that the nanoplatelet LiFe 0.5 Co 0.5 PO 4 /C shows a better capacity capability, delivering a discharge specific capacity of 133.8, 112.1, 98.3, and 74.4 mAh g −1 at 0.1, 0.5, 1, and 5 C rate (1 C = 150 mA g −1 ); the corresponding cycle number is 5th, 11th, 15th, 20th, and 30th, respectively, whereas the nanorod one possesses more excellent cycling ability, with a discharge capacity of 83.3 mAh g −1 and capacity retention of 86.9% still maintained after cycling for 100 cycles at 0.5 C. Results from the present study demonstrate that the LiFe 0.5 Co 0.5 PO 4 solid solution nanomaterials with favorable carbon coating effect combine the characteristics and advantage of LiFePO 4 and LiCoPO 4 , thus displaying a tremendous potential as cathode of lithium-ion battery.

Synthesis and Properties of Co-doped LiFePO4 As Cathode Material Via a Hydrothermal Route for Lithium-Ion Batteries

A Novel Synthesis and Characterization of LiFePO4 and LiFePO4/C As a Cathode Material for Lithium-Ion Battery

Synthesis Process and Properties of V5+-Doped LiFePO4/C

Synthesis of Cathode Material LiFePO4 for Rechargeable Lithium-Ion Battery by Co-Precipitation Method

Synthesis and electrochemical characterization of LiFePO4/C Cathode materials for Li-ion batteries

Synthesis and electrochemical properties of LiFePO4/C composite cathode materials

Synthesis and characterization of LiFe 0.99 Mn 0.01 (PO 4 ) 2.99/3 F 0.01 /C as a cathode material for lithium-ion battery

Synthesis of LiFePO<sub>4</sub> by Co-Precipitation and Optimization of Its Performance

The Co-Doping Effects of Zr and Co on Structure and Electrochemical Properties of LiFePO4 Cathode Materials

LiFe1-x(Ni0.98Co0.01Mn0.01)xPO4/C (x = 0.01, 0.03, 0.05, 0.07) As Cathode Materials for Lithium-Ion Batteries

Improvement of Electrochemical Performance of LiFePO4 Cathode Materials for Lithium-Ion Battery

Preparation and characterization of Ti4+-doped LiFePO4 cathode materials for lithium-ion batteries

Synthesis of LiFePO 4 /C As Cathode Material by a Novel Optimized Hydrothermal Method

Synthesis of LiFe0.4Mn0.4Co0.2PO4/C Cathode Material of Lithium Ion Battery with Enhanced Electrochemical Performance

Synthesis and Electrochemical Performances of Carbon Coated LiFe0.5CO0.5PO4 Solid Solution as Cathode Materials

Enhanced Electrochemical Properties of LiFePO 4 Cathode Materials by Co and Zr Multi-Doping

Electrochemical Properties of LiFePO4/C for Cathode Materials of Lithium Ion Batteries

Preparation and characterization of Na-doped LiFePO4/C composites as cathode materials for lithium-ion batteries

Synthesis and lithium-ion storage performances of LiFe 0.5 Co 0.5 PO 4 /C nanoplatelets and nanorods

Inorganic-based Sol–gel Synthesis of Nano-Structured LiFePO 4 /C Composite Materials for Lithium Ion Batteries

Synthesis and Electrochemical Properties of K-doped LiFePO4/C Composite As Cathode Material for Lithium-Ion Batteries