Abstract:A new potassium-based adsorbent for CO2 capture with Al aerogel used as support is proposed in this work. The adsorbents with different surface modifiers (tetraethyl orthosilicate (TEOS) and trimethyl chlorosilane (TMCS)) and different K2CO3 loadings (10%, 20%, 30% and 40%) were prepared by sol-gel and iso-volume impregnation processes with ambient pressure drying. The CO2 adsorption performance of the adsorbents were tested by a fixed-bed reactor, and their adsorption mechanisms were studied by scanning electron microscopy (SEM), Brunauer Emmett Teller (BET), X-ray diffraction (XRD), Fourier transform infrared (FT-IR) spectroscopy, and X-ray fluorescence spectrometry (XRF). Furthermore, the adsorption kinetics and the cycling performance were investigated. The results show that using TEOS to modify the wet gel can introduce SiO2 to increase the strength of the skeleton. On the basis of TEOS modification, TMCS can further modify –OH, thus effectively avoiding the destruction of aerogel structure during ambient drying and K2CO3 impregnation. In this work, the specific surface area and specific pore volume of Al aerogel modified by TEOS + TMCS are up to 635.32 cm2/g and 2.43 cm3/g, respectively. The aerogels without modification (Al-B), TEOS modification (Al/Si) and TEOS + TMCS modification (Al/Si-TMCS) showed the best CO2 adsorption performance at 20%, 30% and 30% K2CO3 loading, respectively. In particular, the CO2 adsorption capacity and K2CO3 utilization rate of Al/Si-TMCS-30K are as high as 2.36 mmol/g and 93.2% at 70 degrees Celsius (°C). Avrami’s fractional order kinetic model can well fit the CO2 adsorption process of potassium-based adsorbents. Al-B-20K has a higher apparent activation energy and a lower adsorption rate during the adsorption process. After 15 adsorption-regeneration cycles, Al/Si-TMCS-30K maintain a stable CO2 adsorption capacity and framework structure, while the microstructure of Al/Si-30K is destroyed, resulting in a decrease in its adsorption capacity by nearly 30%. This work provides key data for the application of Al aerogel in the field of potassium-based adsorbent for CO2 capture.

K2co3/Al2o3 for Capturing Co2 in Flue Gas from Power Plants. Part 3: Co2 Capture Behaviors of K2co3/Al2o3 in A Bubbling Fluidized-Bed Reactor

Properties of a Nano CaO/Al2O3 CO2 Sorbent

Characteristics of MgO-based Sorbents for CO2 Capture at Elevated Temperature and Pressure

Properties of a Nano CaO/Al<sub>2</sub>O<sub>3</sub>CO<sub>2</sub>Sorbent

Development of New Potassium Carbonate Sorbent for CO2 Capture under Real Flue Gas Conditions

Regenerable MgO-based Sorbents for CO2 Capture at Elevated Temperature and Pressure: Experimental and DFT Study

The Application of Biochar for CO<sub>2</sub> Capture: Influence of Biochar Preparation and CO<sub>2</sub> Capture Reactors

K2CO3-Impregnated Al/Si Aerogel Prepared by Ambient Pressure Drying for CO2 Capture: Synthesis, Characterization and Adsorption Characteristics.

CO2 Capture from Flue Gases Using Three Ca-Based Sorbents in a Fluidized Bed Reactor

Carbon dioxide capture by functionalized solid amine sorbents with simulated flue gas conditions.

Effect of K2CO3·1.5H2O on the Regeneration Energy Consumption of Potassium-Based Sorbents for CO2 Capture

Process Analysis of CO2 Capture from Flue Gas Using Carbonation/calcination Cycles

Experiment and Modeling of Co2 Capture from Flue Gases at High Temperature in A Fluidized Bed Reactor with Ca-Based Sorbents

Experiment And Modeling Of Co(2) Capture From Flue Gases In A Fluidized Bed With Limestone And Dolomite Sorbents

CO2 Sorption and Regeneration Properties of K2CO3/Al2O3-Based Sorbent at High Pressure and Moderate Temperature

Post combustion CO2 capture with calcium and lithium hydroxide

Effect of operating parameters for CO 2 capture from syngas of supercritical water gasification using K 2 CO 3 /γ-Al 2 O 3 composite adsorbent

Potassium-Promoted Γ-Alumina Adsorbent from K2CO3 Coagulated Alumina Sol for Warm Gas Carbon Dioxide Separation

Hydrophobic interface-assisted casting of Al-supported, CaO-based sorbent pellets for high-temperature CO 2 capture

Effect of operating parameters for CO2 capture from syngas of supercritical water gasification using K2CO3/γ-Al2O3 composite adsorbent

Study on CO2 Capture Performance by Potassium-Promoted MgAl-Hydrotalcite Adsorbent