Abstract:A new method is proposed to generate hydrogen in situ at low pressure from powder-pressed recycled aluminum turnings activated with small amounts of NaOH and drops of water. The contribution of this system is that the user can obtain small flows of high-purity hydrogen (>99%) to charge their portable electronic devices in remote places, in a simple, controlled, and safe way, since only water is used. Test tubes that contain tiny amounts of NaOH on their surface can be transported and used without contact. In addition to being a safer system, a smaller amount of NaOH and water is needed compared to other systems, there is no need to preheat the water, and the system can even generate heat. As the feeding is drop by drop, the hydrogen flow can be easily controlled by manual or automatic dosing. The waste obtained is solid and contains mostly aluminum hydroxide with some NaOH and impurities from the waste of origin, which are easy to sell and recycle. A study has been carried out to optimize the type of test tubes and establish critical parameters. The results show that a constant and controllable flow rate of hydrogen can be obtained depending on the drip frequency where the chemical reaction predominates over diffusion, that the optimal amount of NaOH is 20 wt%, that a finer grain size can increase the H2 yield with respect to the stoichiometric value but reduces the instantaneous flow with respect to that obtained with larger grains, and that it is very important to control the density and the impurities to increase porosity and therefore water diffusion. The estimated cost of the hydrogen produced is 3.15 EUR/kgH2 and an energy density of 1.12 kWh/kg was achieved with a test tube of 92% aluminum purity and 20 wt% NaOH.

Controlled Hydrogen Generation by Reaction of Aluminum/sodium Hydroxide/sodium Stannate Solid Mixture with Water

Programming Hydrogen Production via Controllable Emulsification/Demulsification in a Switchable Oil–Water System

Reaction of Aluminium with Alkaline Sodium Stannate Solution As a Controlled Source of Hydrogen

Hydrogen Generation from Coupling Reactions of Sodium Borohydride and Aluminum Powder with Aqueous Solution of Cobalt Chloride

Hydrogen Generation and Stoichiometric Hydrolysis of Core–shell Al-Li-NaBH4 Composite

Controlled Hydrogen Generation by Reaction of Aluminum with Water

Controlled and Safe Hydrogen Generation from Waste Aluminum and Water, a New Approach to Hydrogen Generation

Hydrogen Generation from Mg–LiBH4 Hydrolysis Improved by AlCl3 Addition

Aluminum Hydrolysis for Hydrogen Generation Enhanced by Sodium Hydride

Combined Usage of Sodium Borohydride and Aluminum Powder for High‐performance Hydrogen Generation

Hydrogen generation from hydrolysis of solid sodium borohydride promoted by a cobalt-molybdenum-boron catalyst and aluminum powder

Enhanced hydrogen generation from Al-water reaction mediated by metal salts

Controllable hydrogen generation behavior by hydrolysis of MgH2-based materials

Liquid Metal Activated Aluminum-Water Reaction for Direct Hydrogen Generation at Room Temperature

Research of Hydrogen Generation by the Reaction of Al-based Materials with Water

Controlled hydrogen generation using interaction of artificial seawater with aluminum plates activated by liquid Ga–In alloy

Thermogravimetric Analysis of Hydrogen Production of Al–Mg–Li Particles and Water

Experimental study on characteristics and mechanism of hydrogen production from aluminium–water reaction for carbon-free power generation

Improved Hydrogen Generation from the Hydrolysis of Aluminum Ball Milled with Hydride

A Hybrid Method for Hydrogen Storage and Generation from Water

Experimental Study on Catalyst-Free High-Temperature and High-Pressure Aluminum-Water Reaction Characteristics Using Metal As Energy Carrier