Abstract:_ This article, written by JPT Technology Editor Chris Carpenter, contains highlights of paper URTeC 208307, “A Water-Based Drilling Fluid for Controlling Deep-Reservoir Extreme Conditions in an Abu Dhabi Gas Shale Play,” by Gabe Manescu, SPE, Schlumberger; Balazs Veer, SPE, TotalEnergies; and Panamarathupalayam Balakrishnan, SPE, Schlumberger, et al. The paper has not been peer reviewed. _ A combination of teamwork and fluids technology proved to be the formula for successfully drilling in high-pressure/high-temperature (HP/HT) conditions for an onshore UAE shale gas play. The success achieved in drilling deep [6200-m measured depth (MD)], long-lateral-displacement (2,000-m) wells with an integrated global operator is a combination dependent on frequent, transparent communication between team members. The environmentally acceptable aqueous drilling fluid delivered a barite sag-free operation in these highly deviated wellbores. Introduction The drilling of unconventional HP/HT wells in the Diyab field can experience difficulty in reaching target depth. One significant challenge is the design of a drilling fluid to manage reservoir pressures and temperatures. The reservoir temperature may reach 165.5°C, requiring mud weights (MW) greater than 20 lbm/gal. Tailoring the drilling-fluid formulation to balance economics and environmental regulations while overcoming HP/HT conditions is critical. In the Diyab drilling campaign, special emphasis was placed on designing the drilling fluid and then on its use in 81⁄2-in. reservoir sections. Background The Upper Jurassic (Oxfordian to Middle Kimmeridgian) Diyab formation, also known as the Dukhan formation, has served as the source rock for several major oil and gas fields in the Middle East. The Diyab formation is unique because of its lower porosities, high carbonate mineralogy, and pressure gradient. Despite the lower porosity, the high-carbonate content defines an extremely brittle target conducive to hydraulic fracture stimulation. Several organic-rich intervals exist throughout the Diyab formation and are separated by less-organic tight limestones, which create different flow units. From a developmental perspective, this condition has the potential to create a high-impact stacked play. The extent of the prospective unconventional Diyab formation within the UAE is limited to the onshore north-central UAE, where most of this area is within Block 1, operated by TotalEnergies. The depth of the prospective basal Diyab interval across Block 1 ranges between 3758 and 4115 m. Three unconventional offset wells (DE-02, DE-03, and DE-04) were drilled by ADNOC within Block 1 to test the productivity of the three submembers of the greater Diyab interval (the Jubaila, Hanifa, and Tuwaiq Mountain formations). After determining that the Hanifa formation had the most-promising productivity, the first TotalEnergies appraisal horizontal well, DE-05, was drilled. After drilling this well, the DE-06 well was the second horizontal appraisal well to be drilled. Additionally, two more deep wells, DE-09 and DE-10, were successfully drilled and evaluated.

Successful implementation of HT geothermal drilling technology in Kenya

ERD Record in Shallow Weakly Consolidated Formation with Remarkable Efficiency

Downhole heat management for drilling shallow and ultra-deep high enthalpy geothermal wells

Progress and Prospect of Mid-Deep Geothermal Reinjection Technology

Review of high-temperature geothermal drilling and exploitation technologies

Optimizing Deep Geothermal Drilling for Energy Sustainability in the Appalachian Basin

Key Technology of 240°C High-Temperature Drilling Fluid

Geothermal Energy in Sedimentary Basins: Assessing Techno-economic Viability for Sustainable Development

Utilization method of low-grade thermal energy during drilling based on insulated Drill pipe

Drilling speed-up and production-increasing development practice of ultra deep clastic reservoir based on Geology-Engineering integration in the Tarim Basin, Northwest China

The Key Technologies of Ultra-Deep Hpht Horizontal Wells and Its Application in Shunbei Oilfield of SINOPEC

Research and Test of Drilling and Completion Technology of Geothermal Reinjection Well in Dongying Area

Water-Based Drilling Fluid Helps Control Extreme Conditions in Gas Shale Play

New Generation of HTHP Water Based Drilling Fluid Changing Conventional Drilling Fluids Solutions

Integrated Hydraulic Fracturing Strategy Leads to Successful Execution of the First Highly Deviated Ultra-Deep Well in Tarim Oilfield

Thermal behavior prediction and adaptation analysis of a reelwell drilling method for closed-loop geothermal system

Theoretical understandings, key technologies and practices of tight conglomerate oilfield efficient development: A case study of the Mahu oilfield, Junggar Basin, NW China

Drilling Offshore Wells with High-Performance Water-Based Mud (HPWBM) in Extreme High-Pressure / High-Temperature (HP/HT) Conditions

Application of well logging technology in geothermal resource evaluation: A case study of geothermal water wells in the Qianjiang sag, Jianghan Basin

Parametric study of the geothermal exploitation performance from a HDR reservoir through multilateral horizontal wells: The Qiabuqia geothermal area, Gonghe Basin

Key Technologies and Practice of Ultra-HTHP Drilling in South China Sea