Abstract:The pile foundation under a high-speed railway (HSR) not only bears the self-weight of the superstructure, but also bears a long-term vertical periodic load during its service. In this study, a large-scale vertical dynamic load test and particle flow numerical simulation method were adopted to investigate the axial cyclic performances of open piles in sand. The results from the dynamic test show that under a dynamic load with cyclic load ratios of 0.1 and 0.2, the surface displacement of the pile decays rapidly as the pile distance increases. Moreover, the higher the vibration amplitude and frequency, the larger the surface displacement. The influence range of the soil around the pile is approximately six times of the pile diameter. It is also found that the external frictional resistance of the upper part of the pile decreases, whereas that of the middle part increases. In addition, the internal friction resistance of the lower part of the pile decreases and gradually stabilizes after approximately 200 cycles. The simulation results show that the influence range of the pile on the surrounding soil is approximately 5–8 times the diameter of the pile under the action of dynamic loading; the vertical displacement of the pile mainly occurs at the beginning of the cycles. The total settlement of the pile foundation increases with an increase in the cyclic load ratio. With an increase in the cycle period, the friction resistance values on the outside of the pile and middle part significantly decrease and increase, respectively. After 10 cycles, the resistance gradually stabilizes, and no evident changes in the internal friction resistance of the pile are observed.

Study of Model Test on Bearing Capacity of Screw Piles in Sand

Model Test Study of Bearing Behavior of Small Prefabricated Piles in Soft Soil Area

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

Centrifuge Model Tests on Laterally Loaded Piles in Sand

Model tests on the bearing capacity of precast oxen-ended micro pipe plies in sort soil

STUDY ON VERTICAL BEARING CAPACITY OF LARGE-DIAMETER CAST-IN-SITU THIN-WALL TUBULAR PILE

STUDY ON SINGLE RIGID PILE GROUND IMPROVEMENT MODEL UNDER EMBANKMENT

Soil-pile interaction on an instrumented pile under cyclic axial loads in sand

Performance of laterally loaded H-piles in sand

Model tests comparing the behavior of pre-bored grouted planted piles and a wished-in-place concrete pile in dense sand

Bearing Mechanism and Calculation Method of Screw Pile

Laboratory Model Study on the Pile-Forming Mechanisms and Bearing Deformation Characteristics of CFA Piles

Behavior of Sand Filled Nodular Piles under Compression in Soft Soil Areas

Bearing Characteristics of Screw-Groove Piles: Model Test and Numerical Analysis

Model Test on Load Transfer Mechanism of a Static Drill Rooted Nodular Pile

A test on base bearing capacity of static drill rooted nodular pile

Numerical Analysis of Bearing Capacity of Drilled Displacement Piles with a Screw-Shaped Shaft in Sand

Experimental Study on Bearing Capacity Behavior of Deep Large Diameter Cast-in-place Belled Pile

Model Test on Bearing Characteristic of Static Drill Rooted Energy Pile

Studies on Bearing Characteristic of Open-Ended and Close-Ended Pipe Piles under High-Speed Railway Loadings