Abstract:Introduction The lithium-air batteries have attracted much more attentions because of its high theoretical energy density, which is over 3500 Wh kg -1 . However the lithium-air batteries still have a lot of problems and the problem related with the decomposition of organic liquid electrolytes is the most serious and one of the main research topics in the present stage. Thus, we have developed all-solid-state lithium-air batteries using the inorganic solid electrolytes, which are more stable than the liquid electrolytes. The application of the solid electrolytes to the lithium-air batteries can solve not only the decomposition of electrolytes but also the safety problem and some other problems specific to the liquid such as leakage and volatilization. In this study, an all-solid-state cell consisting of Li anode, Li 1+x Al y Ge 2-y (PO 4 ) 3 (LAGP) solid electrolyte, and LAGP-carbon nanotube (CNT) composite cathode was operated in the pure oxygen atmosphere (so-called Li-O 2 cell) and the fundamental electrochemical performance was examined. Experimental The all-solid-state Li-O 2 cells were fabricated. The LAGP solid electrolyte was synthesized by the conventional solid-phase method. The air electrode was composed of LAGP and multi-walled CNT particles. The composite electrode was fabricated on the LAGP pellet by sintering and Li anode was fused on another side of the LAGP pellet. Li anode was sealed by the plastic film. The cell was put into the bottles connecting to the oxygen gas flow channel. Results and discussion The electrochemical properties of the solid-state lithium-oxygen battery were examined. First of all, the potential for the electrochemical reactions in the Li / LAGP / LAGP-CNT-O 2 cell was investigated using cyclic voltammetry (CV) as shown in Fig. 1a. The measurement was conducted at a scan rate of 10 mV s -1 at room temperature in the O 2 atmosphere. The cell showed the cathodic peak at the potential less than 3 V and anodic peak between 3.1 V and 4.0 V. Then the cell was discharged and charged under the constant current density of 10 mA g-1 in the voltage range of 2.0 - 4.8 V at room temperature (Fig. 1b). The cell showed the voltage of 2.4 V at the beginning of discharge and then the discharge voltage gradually decreased to 2.0 V. The discharge capacity was about 1420 mAh g -1 and the recharge capacity of about 1130 mAh g -1 was obtained in the cell charged up to 4.8 V. It is noteworthy that the charge process starts from 3.0 V and proceeds in the voltage below 4.2 V. This voltage profile in the constant current condition matches the result obtained by CV measurement. Fig. 1c shows the cycle performance under the current density of 10 mA g -1 at room temperature in the voltage region of 1.6 - 4.8 V. The measurement was conducted with the capacity limit of 500 mAh g -1 . Although the discharge voltage decreased with the cycling, the discharge capacity was retained during 10 cycles. The charge capacity was smaller than the discharge capacity and efficiencies of all cycles were 80 ~ 90 %. It results in increasing the amount of remained discharge products after charging, which would caused the decrease of the discharge voltage with cycling. The redox potentials in the all-solid-state Li-O 2 cells are consistent with the potentials for the oxygen reduction reaction and oxygen evolution reaction reported by many researchers. Especially, the cell using the glyme electrolyte, which are well-known as relatively stable liquid electrolytes, shows similar CV results [1]. In addition, the all-solid-state cell showed the repeatedly same charge curve and the rise at the end of the charging. It means that the continuous decomposition of electrolyte and electrode materials does not occur in this voltage region. Therefore, it can be stated that the solid electrolyte is quite stable in the all-solid-state Li-O 2 cells. References [1] H.-G. Jung et al., Nature Chem., 4, 579 (2012). Acknowledgements We are thankful to Kato Foundation for Promotion of Science for supporting the present work.

Clear Representation of Surface Pathway Reactions at Ag Nanowire Cathodes in All-Solid Li–O 2 Batteries

Enabling Highly Stable Li–O2 Batteries with Full Discharge–Charge Capability: the Porous Binder- and Carbon-Free IrNi Nanosheet Cathode

Crystalline SnO2 @ Amorphous TiO2 Core-Shell Nanostructures for High-Performance Lithium Ion Batteries

Surface Mechanism of Catalytic Electrodes in Lithium-Oxygen Batteries: How Nanostructures Mediate the Interfacial Reactions

Ultrastable Anode/Electrolyte Interface in Solid-State Lithium-Metal Batteries Using LiCu x Nanowire Network Host

Investigation of Reaction Mechanism in All-Solid-State Li-Air and Li-O<sub>2</sub> Batteries

Facile Fabrication of Ag Nanocrystals Encapsulated in Nitrogen‐doped Fibrous Carbon as an Efficient Catalyst for Lithium Oxygen Batteries

Investigation of Reaction Mechanism in All-Solid-State Li-Air and Li-O2 Batteries

Ultraviolet Light-Assisted Ag@La 0.6 Sr 0.4 Fe 0.9 Mn 0.1 O 3 Nanohybrids: A Facile and Versatile Method for Preparation of Highly Stable Catalysts in Li-O 2 Batteries

High-Performance Li-O2 Batteries with Controlled Li2O2 Growth in Graphene/Au-Nanoparticles/Au-Nanosheets Sandwich.

Electrochemical performance of All-Solid-State Lithium-Oxygen Batteries

Controlled Growth of Li2o2 by Cocatalysis of Mobile Pd and Co3o4 Nanowire Arrays for High-Performance Li-O-2 Batteries

Au-nanocrystals-decorated Δ-Mno2 As an Efficient Catalytic Cathode for High-Performance Li-O2 Batteries.

Garnet Electrolyte‐Based Integrated Architecture for High‐Performance All‐Solid‐State Lithium‐Oxygen Batteries

Evolution of Discharge Products on Carbon Nanotube Cathodes in Li–O 2 Batteries Unraveled by Molecular Dynamics and Density Functional Theory

Ag nanoparticles incorporated interlayer enables ultrahigh critical current density for Li6PS5Cl-based all-solid-state lithium batteries

Localized surface plasmon resonance enhanced electrochemical kinetics and product selectivity in aprotic Li–O2 batteries

Realizing the Embedded Growth of Large Li2O2 Aggregations by Matching Different Metal Oxides for High-Capacity and High-Rate Lithium Oxygen Batteries

Single‐Atom Catalyst Induced Amorphous Li2O2 Layer Enduring Lithium–Oxygen Batteries with High Capacity

Robust Silver Nanowire Membrane with High Porosity to Construct Stable Li Metal Anodes

Manipulating Interfacial Nanostructure to Achieve High‐Performance All‐Solid‐State Lithium‐Ion Batteries