Abstract:In the operation of HVDC GIL (Gas-insulated Transmission Line), cone-type insulator can separate SF6 chambers, support the HV conductor and play the role of electric insulation. However, with long-term applied HVDC voltage, charges are prone to accumulate on the insulator surface, which can lead to the decrease of flashover voltage and threaten the stability of power system. Besides, the existence of metallic particles inside the GIL chamber, especially those attached along the insulator surface, can result in a more serious charge accumulation. Therefore, it is necessary to measure the surface charge distribution of clean and metal particle contaminated cone-type insulator in order to analyze its insulation properties under HVDC voltage. In this paper, a 3D 4-axis manipulating system is built to control the position of a capacitive probe to measure the surface potential of a +/- 200kV cone-type insulator. The probe keeps perpendicular to the concave surface at an identical distance and takes measurement along a pre-set trajectory after the applied voltage has been interpreted. Surface charge distributions of clean and metallic contaminated cone-type insulators are obtained successively. Influences of voltage polarity and application time are equally studied. The results show that metallic contamination has an enormous influence on surface charge polarities and distribution. For a clean surface, negative charge accumulates along the insulation surface under positive HVDC voltage; while under negative HVDC voltage, charges of both polarities are detected in different areas. For an insulator surface with metallic contamination, charge of the same polarity as the applied voltage is found to be significant near the contamination area. Analyses are made from the perspective of electric field distortion and partial discharge caused by the metallic contamination.

Study on the Poles to Enclosure Insulation Characteristics for High Voltage Shunt Capacitors with Various Electrode Structures

Study of Insulation Protection for Reactive Compensation Capacitors

Study on the Failure Factors of Composite Insulation in High-Voltage Storage Capacitors

Research on the Insulator Surface Charge Accumulation under DC Voltage

Research on insulation characteristics of multi-layers dielectrics under polarity reversal based on field-circuit coupling method

Comparison Analysis of Surface Charge Characteristics and Electric Field Distribution of Post Insulator with Different Structures

Design optimization of power capacitor major insulation based on partial discharge performance

Techniques for capacitor dielectrics characterization

Measurements of Electric Field and Charge on Insulator Surface

Research on Overvoltage of Parallel Capacitors in 500kv Substation and Its Protection Parameters

Electric Field Analysis of Typical Surface Insulation Configurations in Vacuum

2002 Annual Repolt Conference on Electrical Insulation and Dielechic Phenomena Interfacial Space Charge Between ZnO Varistor Ceramics and Coating Materials

Influence of Key Structure Parameters on Electrical Field Distribution of Tri-post Insulator Used in UHV

Surface Charge Behavior and Flashover Performance on Epoxy-Based Spacers by Graded Conductivity Coatings Subjected to DC Voltages

Influence Of Metallic Contamination On Surface Charge Distribution Of A 200kv Cone-Type Insulator

Micro-charge measurement in the insulation test and measurimg technology for high-electrisity field

Comparative Study of Surface Charge Between Epoxy Impregnated Paper and Epoxy Resin

Encapsulation Insulation Failure Mechanisms of Power Module in Circuit Breakers

Design of capacitive electrostatic probes for online measurement of surface charge on ±320 kV tri‐post insulators

Dynamic Observation of Dc Surface Charge Dissipation for Epoxy-Resin/alumina Composite

Influence on Voltage Distribution of Composite Insulator by Inserting Metal Electrodes in Weather Sheds