Abstract:A linear failure criterion is widely used in slope stability analyses. However, the strength envelope of almost all geomaterials has the nature of nonlinearity. This paper computes rigorous upper bounds on slope stability factors under the condition of plane strain with a nonlinear yield criterion by employing the upper bound theorem of plasticity. A stability factor (or a limit load) computed using a linear Mohr-Coulomb (MC) failure criterion which circumscribes the actual nonlinear failure criterion is an upper bound value of the actual stability factor (or limit load). In this paper, an improved method using a generalized tangential technique to approximate a nonlinear failure criterion is proposed to estimate the stability factor of a slope on the basis of the upper bound theorem of plasticity. Using the generalized tangential technique, the curve of the nonlinear failure criterion is simplified as a set of straight lines according to the linear MC failure criterion. The straight line is tangential to the curve of the nonlinear failure criterion. The set of straight lines of the linear MC failure criterion is employed to formulate the slope stability problem as a classical optimization problem. The objective function formulated in this way is minimized with respect to the location of sliding body center and the location of tangency point. Two typical slope stability problems (a homogeneous soil slope with two slope angles and a vertical cut slope with a tension crack) are analyzed using the proposed method. For the soil slope with two slope angles, the computed results are compared with published solutions by others. The comparison shows that the proposed method gives reasonable and consistent values of the stability factor of the slope. For the vertical cut slope with a tension crack, a statically admissible stress field is constructed for the slope. The stress field does not violate the nonlinear failure criterion. Lower bound solutions are obtained by satisfying stress equilibrium conditions. The upper bound solutions obtained from the proposed method are equal to the lower bound solutions for the vertical cut slope. The agreement further supports the validation of the proposed approach. The influences of the strength parameters in the nonlinear criterion on the stability of slopes are also studied and discussed in this paper.

Discussion on Generalized Tangential Method Led in Nonlinear Failure Criterion in Upper Boundary Limit Analysis

A Method for Determining Critical Thickness of Base Soil of Foundation Pit Subjected to Confined Water

Study on the Crack Mechanism and Back Analysis of Mechanics Parameters of the Soil Slope in the New Area of MaGang

Upper Bound Analysis of Tunnel Face Stability in Layered Soils

Kinematical Analysis of Slope Stability Using Triangular Slices Method

Upper Bound Limit Analysis of Slope Stability Based on Translational and Rotational Failure Mechanism

Upper Bound Limit Analysis of Deep Tunnel Face Support Pressure with Nonlinear Failure Criterion under Pore Water Conditions

Slope Stability Analysis with Nonlinear Failure Criterion

Evaluating Slope Stability with 3D Limit Equilibrium Technique and Its Application to Landfill in China

Reliability analysis of progressive failure of strain softening slope

Analysis of the End-Bearing Capacity of Piles in Sand under Limited Region Failure by a Mixed Zero-Extension Line Method

Discrete element analysis and analytical method on failure mechanism of retaining structures with narrow granular backfill

3D Limit Analysis of the Transient Stability of Slope during Pile Driving in Nonhomogeneous and Anisotropic Soil

Numerical analyses for three-dimensional face stability of circular tunnels in purely cohesive soils with linearly increasing strength

Three-dimensional stability analysis of tunnel face considering the upper partial failure in layered rock masses

Kinematic Limit Analysis of Rock and Soil Slope Stability

Seismic Bearing Capacity of Strip Footings with Modified Pseudo-dynamic Method

Upper-bound limit analysis of passive failure of a 3D shallow tunnel face under the bidirectional inclined ground surfaces

Three-Dimensional Upper Bound Limit Analysis on the Collapse of Shallow Soil Tunnels considering Roof Stratification and Pore Water Pressure

A mixed smoothed finite element limit analysis formulation for static and seismic collapse loads

Application of numerical ultimate analysis in identifying the bearing capacity of foundation