Abstract:In some application scenarios of new energy, high voltage gain DC–DC converters are widely employed especially for photovoltaic systems, fuel cell systems, and electric vehicles. The two-stage cascade boost integrated with a coupled-inductor and diode-capacitor voltage multiplier cell has been widely researched due to the advantages of a quadratic voltage gain and low voltage stress for the semiconductor devices. In this paper, the universal ZVS design for a family of quadratic converter is given. The proposed method maintains an extremely high voltage conversion ratio and low voltage stress on the power devices. In addition, the problem of the voltage gain being influenced by the load due to a small excitation inductance selection is solved. Moreover, ZVS operation for all of the switches and ZCS operation for most of the diodes are achieved to lower switching loss and suppress voltage spikes. The active clamp circuit is applied to lower the voltage stress and to control the ZVS operation. The design and operation principles, along with steady state and efficiency analyses of a specific converter are discussed in detail. In addition, a detailed comparison is presented among some similar topologies. Finally, a 320 W prototype circuit is implemented in laboratory to verify the performance of the proposed converter.

Analysis and Derivations for a Family ZVS Converter Based on a New Active Clamp ZVS Cell

A family of non-isolated ZVS DC-DC converter based on a new active clamp cell

Analysis and Design for a New ZVS DC DC Converter with Active Clamping

Family of Enhanced ZCS Single-Stage Single-Phase Isolated AC–DC Converter for High-Power High-Voltage DC Supply

A New Zero Voltage Switching Boost Dc-Dc Converter with Active Clamping

A 1-Mhz ZVS Boost DC-DC Converter with Active Clamping Using GaN Power Transistors

Research of an Active Clamping Current-fed Half-bridge Converter with Input Parallel and Output Series

A New ZVS-PWM Buck Converter with an Active Clamping Cell

Analysis and Design of a High Voltage‐gain Quasi‐z‐source DC–DC Converter

A Zero-Voltage Switching Three-Phase Inverter

Active-Clamp ZVZCS Resonant Forward DC Transformer (DCX) with Load-Adaptive ON-Time Control

Active Clamp ZVS Power Factor Correction Converter With Complementary Control Method

An Improved Active-Clamp Zvs Forward Converter Circuit

A universal ZVS design for a family of quadratic boost converters

Analysis and Design of Zero-Voltage-Switching Multiphase AC/DC Converters

A Family of DC Transformer (DCX) Topologies Based on New ZVZCS Cells with DC Resonant Capacitance

Analysis, Design, and Experimentation of an Isolated Zvt Boost Converter with Coupled Inductors

A Novel ZVZCS Asymmetrical Dual Switch Forward Converter with an Optimized ZCS Cell Based on Active Clamp Reset Technique

Modeling, Analysis and Design of 15kw Zero-Voltage Zero-Current Switched Full Bridge PWM Converter

New ZCT-PWM Cell for DC-DC Converters with Reduced Current Stress and Conduction Loss

Interleaved High Step-Up Converter with Coupled Inductor and Blocking Capacitor