Abstract:The fundamental aspects of site preference of alloying elements on sublattice of the strengthen γ′ phase with L12 structure have not been well understood, which hinders the optimized design of advanced Ni-based high-temperature alloys. In this contribution, the temperature- and composition-dependent site occupying preferences of the binary, ternary, and quaternary of Ni3Al-based γ′ phase alloyed with Mi where Mi represents the additional transitional metals Co, Cr, Cu, Fe, Mn, Mo, Re, Ta, Ti, V, or W atoms (arranged in alphabetical order) chosen frequently, were studied using a two-sublattice thermodynamic model (Ni, Al, Mi)1a(Ni, Al, Mi)3c. The site occupying fractions (SOFs) were calculated based on a thermodynamic database established in this work, where the thermodynamic data of the end-members involved were obtained using first-principles calculations and phonon spectrum calculations. The calculated SOFs results show that there is an obvious site preference for stoichiometry binary Ni3Al, and its site configuration changes from (Al)1a(Ni)3c at room temperature to (Al0.9984Ni0.0015)1a (Al0Ni0.9994)3c at 1273 K. For the γ′ phase with the composition 78Ni-26Al-4Mi (atom ratio and xNi/xAl = 3:1), Mo atoms always preferred to occupy the 1a sublattice (Al site), Co, Mn, and Ti atoms always prefer the 3c sublattice (Ni site) in the whole temperature range, while the site preference of Cr, Cu, Fe, Re, Ta, V, or W atom is affected by temperature. For example, when the heat treatment temperature is lower than 700 K, Cr, Cu, Fe, Ta, V, and W atoms occupy the 1a and 3c sublattice randomly, and Re atoms prefer to 3c sublattice, while when the heat treatment temperature is higher than 1273 K, Cr, Cu, and W atoms prefer 3c sublattice, Fe and Ta atoms prefer to 1a sublattice, while all Re atoms occupy the 3c sublattice exclusively, and all V atoms occupy the 1a sublattice exclusively, respectively. Likewise, the site preference of the quaternary system with selective compositions 78Ni-26Al-2 M1-2 M2 was also predicted. Based on calculated SOFs results, the mechanical and thermodynamic properties were studied at the ground state. It has been revealed that Cr, Re, and V doping can improve the microhardness of Ni3Al alloys; in particular, the effect of Cr is extraordinary; and all elements, except Mn, Mo, and Ti, would enhance the bulk modulus of Ni3Al-based γ′ phase, in which Mn have the greatest influence on reducing the bulk and shear modulus, respectively. Furthermore, all the B/G ratios of the computed Ni3Al-based γ′ phase are >1.75, showing inherent ductility. Only Cr doping significantly enhances the Debye temperature of the Ni3Al-based γ′ phase.

The First-Principles Study on the Doping Effect of Re in Ni3Al

Re effects in model Ni-based superalloys investigated with first-principles calculations and atom probe tomography*

First-principles Study of Vacancy Formation and Migration in Clean and Re-doped Γ′-Ni3al

Effect of Re in Gamma Phase, Gamma ' Phase and Gamma/Gamma ' Interface of Ni-Based Single-Crystal Superalloys

Study of Re strengthening mechanisms in nickel-based superalloy

Effect of Re on mechanical properties of single crystal Ni-based superalloys: Insights from first-principle and molecular dynamics

First-principles Study of Ni/Ni3Al Interface Doped with Re, Ta and W

A First-Principles Study of B2 Nial Alloyed with Rare Earth Elements Pr, Pm, Sm, and Eu

First-principles Study of NiAl Microalloyed with Sc, Y, La and Nd

Research on the Effect Mechanism of Re on Interface Dislocation Networks of Ni–Based Single Crystal Alloys

Influence of Re on the Propagation of A Ni/Ni-3 Al Interface Crack by Molecular Dynamics Simulation

A First-Principles Study on the Doping Stability and Micromechanical Properties of Alloying Atoms in Aluminum Matrix

Element Interactions and Local Structure in Molten NiRe and NiAlRe Alloys: Implications for the Aggregation and Partition of Re

Effects of Alloying Re and Ru in the Edge-Dislocation Core of the Ni/Ni3al Interface

First-principles Study of NiAl Alloyed with Rare Earth Element Ce

The Effects of Key Elements Re and Ru on the Phase Morphologies and Microstructure in Ni-based Single Crystal Superalloys

First-principles studies of Al–Ni intermetallic compounds

Site preferences of alloying transition metal elements in Ni-based superalloy: A first-principles study

The site preference and doping effect on mechanical properties of Ni3Al-based γ′ phase in superalloys by combing first-principles calculations and thermodynamic model

Energetics And Electronic Structure Of Re And Ta In The Gamma ' Phase Of Ni-Based Superalloys

Study of the Point Defect, Re Site, and Re Cluster in Re Embedded Ni3al Using the Embedded Atom Method