Influence of CO2 Dissolving in Formation Water on CO2 Flooding Process

TANG Yong,DU Zhimin,SUN Lei,LIU Wei,CHEN Zuhua
DOI: https://doi.org/10.7623/syxb201102019
IF: 1.468
2011-01-01
Acta Petrologica Sinica
Abstract:It was pursued to compare simulation results in which CO2 dissolution in the aqueous phase was either ignored or considered.The solubility law of CO2 in the aqueous phase was investigated by using a CO2-hydrocarbon-water equilibrium thermodynamic model.This compositional model combined with the Henry Law was then applied to a one-dimensional long-core simulator,in which a series of one-dimensional continuous CO2 flooding was simulated with or without CO2 dissolution in the aqueous phase at different initial water saturation.The difference caused by CO2 flooding was discussed in terms of variation laws for oil recovery,gas to oil ratio,oil-gas-water saturated profiles and CO2 mole fraction profiles in oils and formation water.The results showed that the amount of CO2 dissolving in formation water increased with the increase of pressure but decreased with increasing temperature.The effect of pressure or temperature on the CO2 dissolved amount in the aqueous phase became diminishing either as temperature rose to 100℃ or as pressure reached up to 20MPa.During the early stage of gas injection,the oil recovery with the presence of CO2 dissolution was lower than that without the presence of CO2 dissolution,moreover,with the presence of CO2 dissolution the gas breakthrough time was later and oil banks toward to production wells were lagging behind,therefore,the higher the water saturation,the greater the effect of CO2 dissolution.When water saturation was 0.67 and the CO2 amount double of the hydrocarbon pore volume was injected,the ultimate oil recovery with the presence of CO2 dissolution was 6% less than that without the presence of CO2 dissolution.The effectiveness of CO2 flooding might be delayed due to the CO2 loss caused by CO2 dissolution in formation water.
What problem does this paper attempt to address?