Abstract:We report high-pulse-energy ultrafast 3 mu m laser generation through optical parametric generation/difference frequency generation (OPG/DFG) in periodically poled magnesium-oxide-doped lithium niobate (PPMgLN). A commercial 1030 nm femtosecond laser is applied as the pump light and a homemade broadband nanosecond pulse laser around 1580 nm is used as the signal light in DFG. The broadband 1580 nm laser has a master oscillator power amplifier (MOPA) structure with a directly modulated superluminescent light-emitting diode (SLED) as the pulse seed and three stages of Er/Yb fiber amplifiers to lift its average power. A portion of the 1030 nm output pulse is converted to an electronic pulse via a pin detector, which is used as the trigger signal of the SLED driving circuit to ensure synchronization between the signal and the 1030 nm pump pulse. When injecting 2.12 W pump light into the PPMgLN, a broadband mid-infrared (MIR) output of 280 mW can be achieved directly through OPG with a center wavelength around 2.94 mu m, a pulse width of 1.38 ps and a pulse repetition frequency of 500 kHz. The corresponding MIR pulse energy is 0.56 mu J. When injecting 2.62 W signal light simultaneously, a MIR output of 300 mW is achieved through the DFG process at the same pulse repetition frequency, corresponding to a pulse energy of 0.6 mu J. The conversion efficiency of the ultrafast pump laser to MIR reaches 14.1%. This high-pulse-energy 3 mu m ultrafast laser has great prospects for applications in biological tissue ablation.

High-repetition-rate Femtosecond Optical Parametric Oscillator–amplifier System Near 3 Μm

Non-Critically Phase-Matched Femtosecond Optical Parametric Oscillator Near 3 Microns

Amplification Assisted Optical Parametric Oscillator in the Mid-Infrared Region

High-repetition rate optical parametric chirped pulse amplification system for attosecond science experiments

Broadband High-Power Mid-Ir Femtosecond Pulse Generation from an Ytterbium-Doped Fiber Laser Pumped Optical Parametric Amplifier

High Repetition Rate and High Power Picosecond Terahertz Parametric Amplifier with a KTiOPO4 Crystal

Femtosecond Optical Parametric Amplifier for Petawatt Nd : Glass Lasers

A CW Seeded Femtosecond Optical Parametric Amplifer

3 GHz, Yb-fiber laser-based, few-cycle ultrafast source at the Ti:sapphire laser wavelength

3 μm mid-infrared compact intracavity optical parametric oscillator based on KTA and MgO:PPLN

High peak-power 2.1-μm femtosecond Holmium amplifier at 100 kHz

Picosecond-Pulse-Pumped Efficient Optical Parametric Amplifier for Non-Chirped Femtosecond Pulses

High Repetition Rate, 4 Μm Mid-Infrared Generation with Periodically Poled Magnesium-Oxide-Doped Lithium Niobate Based Optical Parametric Oscillator Pumped by Fiber Laser

100Hz High Energy KTiOAsO4 Optical Parametric Oscillator

Efficient 1.8 Μm KTiOPO4 Optical Parametric Oscillator Pumped Within an Nd:YAG/SrWO4 Raman Laser.

Direct ultrafast parametric amplification pumped by a picosecond thin-disk laser

A High Energy 3.75 Μm KTA Optical Parametric Oscillator at a Critical Angle

High-pulse-energy Ultrafast 3 Μm Laser Generation Through OPG/DFG in PPMgLN

Generation of few-cycle radiation pulses in the IR spectral range (1.3 – 2.2 μm) using wide-aperture BBO crystals pumped by a terawatt Ti : sapphire laser

15-µJ picosecond hollow-core-fiber-feedback optical parametric oscillator

75 MW few-cycle mid-infrared pulses from a collinear apodized APPLN-based OPCPA