Abstract:The moving bed biofilm reactor (MBBR) has certain advantages, such as high wastewater treatment efficiency, low maintenance and operating costs, and simple operation. It has emerged as a valuable option for small decentralized facilities. The filling ratio, aeration mode and aeration intensity are the main factors that affect the performance of MBBRs in wastewater treatment. However, the information that concerns the used criteria that pertain to the process design for the MBBR is not adequate. In this study, a three dimensional computational fluid dynamics (CFD) model was constructed and the maximum error was only 1.98%, which was much smaller than the traditional 2D-CFD model. The filling ratio, aeration mode and aeration intensity of MBBR were optimized by CFD model from the point of view of fluid mechanics. The results show that the fluidization performance of the filling is the best under the one-side aeration mode with 30% filling ratio. The cost-performance ratio of the reactor with 30% filling ratio was 1.53, 25% and 35% filling ratio were only 1.17 and 1.14 respectively. Increasing the aeration intensity could improve the fluidization performance. However, the effect of high aeration intensity on the fluidization performance of the carrier was limited and the energy consumption increased greatly. The results revealed that when the aeration intensity increased from 0.07 min-1 to 0.13 min-1, the proportion of the carrier area increased by 16.56%. The proportion of the carrier area with an aeration rate of 0.20 min-1 was only 4.23%, which is higher than 0.13 min-1. The main factors that control the fluidization of the carrier were the range of the flow zone and the flow velocity of the liquid. Increasing the range of the flow zone could facilitate the flow of the carriers. The critical value of the flow velocity of the liquid in the flow zone was 0.04 m/s. These results could guide the optimization design of the filling ratio and the aeration conditions and provide a theoretical basis for the application of MBBR.

Oxygen Mass Transfer Coefficients Comparison of Two Different Carriers in the Moving Bed Biofilm Reactor

Impact of Saddle-Chips Biocarrier on Treating Mariculture Wastewater by Moving Bed Biofilm Reactor (MBBR): Mechanism and Kinetic Study

Performance of Novel Sponge Biocarrier in MBBR Treating Recirculating Aquaculture Systems Wastewater: Microbial Community and Kinetic Study.

Start-up Evaluations and Biocarriers Transfer from a Trickling Filter to a Moving Bed Bioreactor for Synthetic Mariculture Wastewater Treatment.

Enhancement of Mariculture Wastewater Treatment Using Moving Bed Biofilm Reactors Filled with Modified Biocarriers: Characterisation, Process Performance and Microbial Community Evaluation

17Β-Estradiol Removal Routes by Moving Bed Biofilm Reactors (mbbrs) under Various C/N Ratios

Oxygen transfer improvement in MBBR process

Effects mechanism of bio-carrier filling rate on rotating biofilms and the reactor performance optimization method

[Experiment Study on Carriers in Moving Bed Biofilm Reactor].

Influence of Carrier Concentration on the Performance and Microbial Characteristics of a Suspended Carrier Biofilm Reactor

Influence of filling ratio and carrier type on organic matter removal in a moving bed biofilm reactor with pretreatment of electrocoagulation in wastewater treatment

Numerical study of hydrodynamic characteristics in a moving bed biofilm reactor

Characteristics of oxygen mass transfer and its impact on pollutant removal performance and microbial community structure in an aerobic fluidized bed biofilm reactor for treatment of municipal wastewater

Performance and Bacterial Community of Moving Bed Biofilm Reactors with Various Biocarriers Treating Primary Wastewater Effluent with a Low Organic Strength and Low C/N Ratio

Moving Bed Biofilm Reactor for Treatment of Mixed Domestic and Industrial Wastewater

[Pilot-Scale Study on Treatment of Municipal Sewage by Moving-Bed Biofilm Reactor with the Hydrophobically Modified Polyurethane Cubes As Biofilm Carriers].

Impacts of bio-carriers on the characteristics of cake layer and membrane fouling in a novel hybrid membrane bioreactor for treating mariculture wastewater

Kinetic mechanism of methanol decomposition on Ni(111) surface: a theoretical study.

Effects of Porous Carrier Size on Biofilm Development, Microbial Distribution and Nitrogen Removal in Microaerobic Bioreactors.

Improvement of MBBR-MBR Performance by the Addition of Commercial and 3D-Printed Biocarriers

Effect of carriers on sludge characteristics and mitigation of membrane fouling in attached-growth membrane bioreactor.