Influence of Frequency on Electrical Tree Initiation in Polyethylene

Yuan-xiang ZHOU,Yi-nan WANG,Xiao-liang XING,Yuan-shan WANG,Ning-hua WANG,Xi-dong LIANG,Zhi-cheng GUAN
DOI: https://doi.org/10.3969/j.issn.1003-6520.2007.04.035
2007-01-01
Abstract:Treeing degradation in dielectric polymers often leads to insulation failures in electrical equipment. In order to make out the breakdown failures, the tree initiation characteristics of ice- water quenched HDPE under AC voltage in frequencies ranging from 50 Hz to 90 kHz are studied. It is found that the tree initiation voltages (TIV) change a little when the frequency is from 50 Hz to 1 kHz. When the frequency is higher than 1 kHz,the TIV increases with the increase of frequency before reaching a maximum TIV. While the TIV decreases at first then increases at frequency 10 kHz. There are 7 categories of tree shapes, including branch- like, trunk- like, bosk- like, direct breakdown, bosk- trunk, bosk- breakdown and branch- trunk, appeared in the experiment. The categories of tree shapes manifold with the frequency increasing. The TIV of different categories are different apparently. The breakdown shape shows the highest TIV while the branch- like one shows the lowest TIV. The damage degrees to insulation material are different for different categories. It is also found that as the frequency increases, the dispersion of TIV increases remarkably. Though the polymer shows higher average TIV values as the frequency is larger than 1 kHz, the larger dispersion in higher frequency region indicates that the application of polymer insulators in medium or high frequency area would bring a higher breakdown risk as one can find from the frequent insulation failures in high frequency machines. The influence of frequency on electron accelerating process and fatigue effect aggravation in material under high frequency are considered as main causes of the experiment results.
What problem does this paper attempt to address?