Effect of Frequency on Electrical Treeing Characteristicsof High-density Polyethylene

ZHOU Yuan-xiang,NIE Qiong,XING Xiao-liang,WANG Yun-shan,WANG Ning-hua,LIANG Xi-dong,GUAN Zhi-cheng
DOI: https://doi.org/10.13336/j.1003-6520.hve.2008.02.021
2008-01-01
Abstract:The characteristics of electrical treeing in ice-water quenched high-density polyethylene (HDPE) film under AC voltage of different frequency ranging from 50 Hz to 90 kHz was studied. The electrical treeing experiments are carried out at room-temperature. The processes of electrical treeing during the experiment are observed via a digital micro-observing system. It was found that under different frequency of applied voltage the initiation shape of electrical tree was different, it means the different mechanisms of electrical tree initiation. There are 4 kinds of trees in inception period: branch tree, trunk tree, bush tree and breakdown tree. Trunk tree and breakdown tree with high initiation speeds are special kinds appearing in high frequency (HF). The branch tree is the primary shape in the range of low frequency, while the bush tree is the primary shape in the range of HF. With the increase of frequency, the occurrence ratio of branch tree decreases, while the occurrence ratio of bush tree increases. It was also shown that as the propagation of electrical tree, the conversion of tree shape is strongly affected by the frequency. The electrical tree usually has a simple shape and rarely changes under low frequency in one hour or more. However, in the case of a higher frequency, the electrical tree shape changes more frequently and has a large probability to breakdown. The result also showed that there were 4 steps in the electrical tree propagating process: initiation step, stagnation step, growth step and breakdown step. Under the same voltage, high frequency could accelerate the electrical tree propagation. Higher frequency could speed up the tree growing and increase the probability of breakdown caused by electrical tree. The influence of frequency on material polarization process, fatigue and thermo effect were considered as the main causes of the experiment results. The more serious destruction caused by high frequency electrical treeing degradation can well explain the reason of insulation premature inactivation in mid-frequency or high-frequency electrical equipment.
What problem does this paper attempt to address?