Abstract:Variations in biomass-derived syngas composition can be a challenge to efficient combustion and low emissions. A study on the effects of CO2 dilution and CH4 addition on flame propagating characteristics of syngas at high pressure was conducted using the heat flux method and kinetic simulations. This paper presents the laminar burning velocity, S-L of H-2/CO/CO2/O-2/diluent mixtures and H-2/CO/CH4/O-2/diluent at phi 0.5-2.5, elevated pressures one-11 atm and H-2-CO mole fraction ratios 0.25:0.75 to 0.75:0.25. The effects of CO2 mole fraction dilution in the fuel (from 0.0 to 0.4), CH4/(CH4+CO) (from 0.0 to 1.0), and pressure dependence on S-L were experimentally investigated and compared to the simulated results from three kinetic mechanisms. The increase of the hydrogen mole fraction, or the decrease of the CO2 mole fraction in the fuel, both lead to an increase of S-L; the decreased mole fraction enhanced S-L significantly more in over-rich conditions. The dilution, thermal-diffusion, and chemical effects (including the direct reaction and three-body effects) of CO2 dilution were quantitively distinguished at different pressures and H-2 contents. The results showed that increasing the pressure and CO2 mole fraction in the fuel enhanced the competition of H consuming reactions, and the retarding effect of CO2 dilution was found to be favored at high hydrogen content syngas conditions. Both CO2 dilution and CH4 addition decreased the overall reaction order of the syngas flames by decreasing the adiabatic flame temperature. Increasing the pressure and H-2 content increased the syngas heat release rate by enhancing three-body collision reactions and enrichment of H radical, and their effects were reversed on syngas flame speed.

Study for Entrained-Flow Gasifier Modeling and Measurement

Syngas composition study

Experimental Study and Simulation of Low-Temperature Gasification of Municipal Solid Waste in Circulated Fluidized Bed

Study on the Modeling of Staged Entrained Flow Gasifier

Modeling study of Tsinghua oxygen staged entrained-flow gasifier

Investigation of laminar flame speeds of typical syngas using laser based Bunsen method and kinetic simulation

Thermodynamic modeling modification and experimental validation of entrained-flow gasification of biomass

Modeling for an entrained flow coal gasifier with partitioning zone approach

Measurement of Laminar Flame Velocity of Premixed Syngas Flame by Heat-Flux Method

Laminar Flame Speed and Markstein Length of Syngas at Normal and Elevated Pressures and Temperatures

CPFD Simulation on Particle Behaviour in an Entrained-Flow Gasifier

Entrained-Flow Coal Gasification Process Simulation with the Emphasis on Empirical Char Conversion Models Optimization Procedure

Experiment study on staged entrained flow coal gasification

A Simplified Equilibrium Model For Simulating Entrained Flow Gasifiers

Analysis of the Gasification Performance of a Staged Entrained Flow Gasifier by Presumed PDF Model

Three-dimensional Numerical Simulation of Entrained-Flow Gasifier and Influence of Coal Distribution at the Inlet

Modelling on Effects of Operation Parameters on Entrained Flow Coal Gasification (I): Model Establishment and Validation

The application of thermal-calculation methods in the design and syngas prediction of entrained-flow coal gasifiers

Simulation of Biomass Gasification and Application in Pilot Plant

Effects of CO2 Dilution and CH4 Addition on Laminar Burning Velocities of Syngas at Elevated Pressures: an Experimental and Modeling Study

Effects of CO 2 Dilution and CH 4 Addition on Laminar Burning Velocities of Syngas at Elevated Pressures: An Experimental and Modeling Study